fuyuno sakura / Mbed 2 deprecated datalogger1

mbed Datalogger for KOHZU SC-410 4Axis Controller and Micrometer which has RS232C output p30 TRG IN: TRG OUT(Linked to pulse motor Axis CW/CCW PULSE) of SC-410 *needs change opendrain mode, and pull up to +3.3 or +5V* p13 TRG OUT: 50Hz output of TRIGGER to Micrometer p10 Serial RX:Micrometer RS232C output, *CMOS LEVEL,Converter needed* mbed HDK Serial :Coupling Pulse count and RS232C data output

Dependencies:   mbed

You are viewing an older revision! See the latest version

Homepage

Table of Contents

  1. mbed Datalogger Helper for KOHZU SC-410 4Axis Controller and Micrometer which has RS232C output.

mbed Datalogger Helper for KOHZU SC-410 4Axis Controller and Micrometer which has RS232C output.

Pin Assignment

  • p30 TRG IN: TRG OUT(Linked to pulse motor Axis CW/CCW PULSE) of SC-410 *needs change opendrain mode, and pull up to +3.3 or +5V*
  • p13 TRG OUT: 50Hz output of TRIGGER to Micrometer
  • p10 Serial RX:Micrometer RS232C output, *CMOS LEVEL,Converter needed*
  • mbed HDK Serial :Coupling Pulse count and RS232C data output 

[SC-410 side]

                              +---vvvv------- VU (mbed +5V)
                              |
----|>o---------SC410TRG------+-------------- p13
                              |
----------------SC410GND------+-------------- GND (mbed GND)

[Micrometer Side]

        OC Driver
p30 ----- |>o----- TRGIN (Micrometer)

GND -------------- GND (if needed)

p10 ------o<|----- RS232C TX
        LEVEL
      CONV(232C->CMOS)
All wikipages