first 2016/02 SDFileSystemDMA inherited from Official SDFileSystem.
Dependents: SDFileSystemDMA-test DmdFullRGB_0_1
Fork of SDFileSystemDMA by
SDFileSystemDMA is enhanced SDFileSystem library for STM32 micros by using DMA functionality.
Max read transfer rate reaches over 2MByte/sec at 24MHz SPI clock if enough read buffer size is set.
Even though minimum read buffer size (512Byte) is set, read transfer rate will reach over 1MByte/sec at 24MHz SPI Clock.
( but depends on the ability of each SD card)
Test program is here.
https://developer.mbed.org/users/mimi3/code/SDFileSystemDMA-test/
Supported SPI port is shown below table.
(v): Verified. It works well.
(w): Probably it will work well. (not tested)
(c): Only compiled. (not tested)
(f): Over flash.
(r): Only read mode. (when _FS_READONLY==1)
(u) Under construction
(z): Dose not work.
Caution
If your board has SRAM less than or equal to 8KB, the buffer size must be set to 512 Bytes.
Supported Boards:
Cortex-M0
Board | SRAM | SPI1 | SPI2 | SPI3 |
---|---|---|---|---|
NUCLEO-F030R8 | 8KB | (v) | ||
DISCO-F051R8 | 8KB | (w) | ||
4KB | (f) | |||
NUCLEO-F042K6 | 6KB | (r) | ||
NUCLEO-F070RB | 16KB | (w) | ||
NUCLEO-F072RB | 16KB | (w) | ||
NUCLEO-F091RC | 32KB | (c) |
Cortex-L0
Board | SRAM | SPI1 | SPI2 | SPI3 |
---|---|---|---|---|
DISCO-L053C8 | 8KB | (c) | ||
NUCLEO-L053R8 | 8KB | (c) | ||
NUCLEO-L073RZ | 20KB | (c) |
Cortex-M3
Board | SRAM | SPI1 | SPI2 | SPI3 |
---|---|---|---|---|
DISCO-F100RB | 8KB | (v) | (v) | - |
BLUEPILL-F103CB | 20KB | (w) | (w) | - |
NUCLEO-F103RB | 20KB | (v) | (v) | - |
NUCLEO-L152RE | 80KB | (v) | (w) | - |
MOTE-L152RC | 32KB | (w) | (w) | - |
Cortex-M4
F3
Board | SRAM | SPI1 | SPI2 | SPI3 |
---|---|---|---|---|
DISCO-F303VC | 40KB | - | (v) | (v) |
NUCLEO-F303RE | 64KB | (w) | (w) | (w) |
NUCLEO-F302R8 | 16KB | - | - | (c) |
NUCLEO-F303K8 | 12KB | (c) | - | - |
DISCO-F334C8 | 12KB | (c) | - | - |
NUCLEO-F334R8 | 12KB | (c) | - | - |
F4
Board | SPI1 | SPI2 | SPI3 |
---|---|---|---|
ELMO-F411RE | (w) | - | (w) |
MTS-MDOT-F411RE | (u) | - | (u) |
MTS-DRAGONFLY-F411RE | (w) | - | (w) |
NUCLEO-F411RE | (v) | - | (v) |
NUCLEO-F401RE | (w) | - | (w) |
MTS-MDOT-F405RG | (u) | - | (u) |
NUCLEO-F410RB | (c) | - | (c) |
NUCLEO-F446RE | (c) | - | (c) |
NUCLEO-F429ZI | (c) | - | (c) |
B96B-F446VE | (c) | - | (c) |
NUCLEO-F446ZE | (c) | - | (c) |
DISCO-F429ZI | (u) | - | (u) |
DISCO-F469NI | (c) | - | (c) |
Information
This library is set to use "short file name" in SDFileSystemDMA/FATFileSystem/ChaN/ffconf.h . ( _USE_LFN=0)
You can change this option to _USE_LFN=1 .
Diff: table.md
- Revision:
- 28:dfef1e7f08c9
- Parent:
- 26:fd7d88d7a4a2
- Child:
- 32:49edbe5337d6
--- a/table.md Sat Feb 20 13:43:58 2016 +0900 +++ b/table.md Sat Feb 20 13:44:01 2016 +0900 @@ -1,16 +1,17 @@ Test program is here.\\ [[https://developer.mbed.org/users/mimi3/code/SDFileSystemDMA-test/]]\\ - + {{/media/uploads/mimi3/sdfilesystemdma-speed-test2.png}} -Basically only **SPI1** or **SPI2** is supported, see below table. +Supported SPI port is shown below table.\\ + +** (v): Verified. It works well. ** \\ +** (w): Probably it will work well. ** \\ +** (c): Only compiled. ** \\ +** (f): Over flash. ** \\ +** (z): Dose not work. ** \\ Supported Boards:\\ -** (v): Verified. It works well. ** \\ -** (w): Probably it will work. ** \\ -** (c): Only compiled. ** \\ -** (f): Over flash. ** - **Cortex-M0** |=Board |=SPI1|=SPI2|=SPI3| |NUCLEO-F030R8|**(v)**||| @@ -22,27 +23,27 @@ |NUCLEO-F091RC|(c)||| |DISCO-L053C8 |(c)||| |NUCLEO-L053R8|(c)||| -|NUCLEO-L073RZ|(???)||| +|NUCLEO-L073RZ|(c)||| ** Cortex-M3 ** |=Board |=SPI1|=SPI2|=SPI3| -| DISCO-F100RB |(w)||| -| NUCLEO-F103RB|(w)||| -| NUCLEO-L152RE|**(v)**||| +| DISCO-F100RB |**(v)**|**(v)**|-| +| NUCLEO-F103RB|**(v)**|**(v)**|-| +| NUCLEO-L152RE|**(v)**|(w)|-| ** Cortex-M4 ** \\ ** F3 ** |=Board |=SPI1|=SPI2|=SPI3| -| DISCO-F303VC |-||**(v)**| -| NUCLEO-F303RE||-|(w)| +| DISCO-F303VC |-|**(v)**|**(v)**| +| NUCLEO-F303RE|(w)|(w)|(w)| | NUCLEO-F302R8|-||(w)| | NUCLEO-F303K8|(w)|-|-| | DISCO-F334C8 |(w)|-|-| | NUCLEO-F334R8|(w)|-|-| ** F4 ** |=Board |=SPI1|=SPI2|=SPI3| -| NUCLEO-F411RE |**(v)**||| -| NUCLEO-F401RE |(w)||| -| NUCLEO-F410RB |(c)||-| -| NUCLEO-F446RE |(c)||| +| NUCLEO-F411RE |**(v)**|-|**(v)**| +| NUCLEO-F401RE |(w)|-|(w)| +| NUCLEO-F410RB |(c)|-|(c) +| NUCLEO-F446RE |(c)|-|(c)|