mbed library sources. Supersedes mbed-src.

Dependents:   Nucleo_Hello_Encoder BLE_iBeaconScan AM1805_DEMO DISCO-F429ZI_ExportTemplate1 ... more

targets/TARGET_TOSHIBA/TARGET_TMPM3HQ/sleep.c

Committer:
AnnaBridge
Date:
2019-02-20
Revision:
189:f392fc9709a3

File content as of revision 189:f392fc9709a3:

/* mbed Microcontroller Library
 * (C)Copyright TOSHIBA ELECTRONIC DEVICES & STORAGE CORPORATION 2018 All rights reserved
 *
 * Licensed under the Apache License, Version 2.0 (the "License");
 * you may not use this file except in compliance with the License.
 * You may obtain a copy of the License at
 *
 *     http://www.apache.org/licenses/LICENSE-2.0
 *
 * Unless required by applicable law or agreed to in writing, software
 * distributed under the License is distributed on an "AS IS" BASIS,
 * WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
 * See the License for the specific language governing permissions and
 * limitations under the License.
 */
#include "sleep_api.h"
#include "gpio_include.h"

static void warming_up_time(void);

void hal_sleep(void)
{
    // Set low power consumption mode IDLE
    TSB_CG->STBYCR = CG_STBY_MODE_IDLE;
    __DSB(); // Enter idle mode
    __WFI();
}

void hal_deepsleep(void)
{
    uint32_t tmp = 0;

    TSB_CG_FSYSENB_IPENB31 = ENABLE;
    while ((TSB_FC->SR0 & 0x01) != 0x01) {
        // Flash wait
    }

    while (TSB_CG_WUPHCR_WUEF) {
        // Wait for end of Warming-up for IHOSC1
    }

    TSB_CG_WUPHCR_WUCLK = DISABLE;
    warming_up_time();
    TSB_CG->STBYCR = CG_STBY_MODE_STOP1;
    TSB_CG_PLL0SEL_PLL0SEL = DISABLE;

    while (TSB_CG_PLL0SEL_PLL0ST) {
        // Wait for PLL status of fsys until off state(fosc=0)
    }

    TSB_CG_PLL0SEL_PLL0ON = DISABLE;  // Stop PLL of fsys
    TSB_CG_OSCCR_IHOSC1EN = ENABLE;
    TSB_CG_OSCCR_OSCSEL   = DISABLE;

    while (TSB_CG_OSCCR_OSCF) {
        // Wait for fosc status until IHOSC1 = 0
    }

    tmp = TSB_CG->OSCCR;
    tmp &= EXTERNEL_OSC_MASK;
    TSB_CG->OSCCR = tmp;
    TSB_CG_OSCCR_IHOSC2EN = DISABLE;

    while (TSB_CG_OSCCR_IHOSC2F) {
        // Wait for status of OFD until off "0"
    }

    __DSB();
    __WFI();
}

static void warming_up_time(void)
{
    uint32_t work = 0;
    uint64_t x    = 0;

    x = (uint64_t)(IHOSC_CFG_WARM_UP_TIME * IHOSC_CFG_CLOCK);
    x = (uint64_t)(x / (uint64_t)(1000000));

    work =   (uint32_t)x;
    work &=  (uint32_t)(0xFFFFFFF0);
    work <<= 16;
    work |=  (uint32_t)(TSB_CG->WUPHCR & ~CGWUPHCR_WUPT_HIGH_MASK);
    TSB_CG->WUPHCR = work;
}