Diff: cmsis/BUILD/mbed/hal/sleep_api.h

Revision:

189:f392fc9709a3

--- /dev/null	Thu Jan 01 00:00:00 1970 +0000
+++ b/cmsis/BUILD/mbed/hal/sleep_api.h	Wed Feb 20 22:31:08 2019 +0000
@@ -0,0 +1,103 @@
+
+/** \addtogroup hal */
+/** @{*/
+/* mbed Microcontroller Library
+ * Copyright (c) 2006-2013 ARM Limited
+ * SPDX-License-Identifier: Apache-2.0
+ *
+ * Licensed under the Apache License, Version 2.0 (the "License");
+ * you may not use this file except in compliance with the License.
+ * You may obtain a copy of the License at
+ *
+ *     http://www.apache.org/licenses/LICENSE-2.0
+ *
+ * Unless required by applicable law or agreed to in writing, software
+ * distributed under the License is distributed on an "AS IS" BASIS,
+ * WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
+ * See the License for the specific language governing permissions and
+ * limitations under the License.
+ */
+#ifndef MBED_SLEEP_API_H
+#define MBED_SLEEP_API_H
+
+#include "device.h"
+
+#if DEVICE_SLEEP
+
+#ifdef __cplusplus
+extern "C" {
+#endif
+
+/**
+ * \defgroup hal_sleep sleep hal requirements
+ * Low level interface to the sleep mode of a target.
+ *
+ * # Defined behaviour
+ *
+ * * Sleep mode
+ *   * wake-up time should be less than 10 us - Verified by sleep_usticker_test().
+ *   * the processor can be woken up by any internal peripheral interrupt  - Verified by sleep_usticker_test().
+ *   * all peripherals operate as in run mode - not verified.
+ *   * the processor can be woken up by external pin interrupt - not verified.
+ * * Deep sleep
+ *   * the wake-up time should be less than 10 ms - Verified by deepsleep_lpticker_test().
+ *   * lp ticker should wake up a target from this mode - Verified by deepsleep_lpticker_test().
+ *   * RTC should wake up a target from this mode - not verified.
+ *   * an external interrupt on a pin should wake up a target from this mode - not verified.
+ *   * a watchdog timer should wake up a target from this mode - not verified.
+ *   * High-speed clocks are turned off - Verified by deepsleep_high_speed_clocks_turned_off_test().
+ *   * RTC keeps time - Verified by rtc_sleep_test().
+ *
+ * # Undefined behaviour
+ *
+ * * peripherals aside from RTC, GPIO and lp ticker result in undefined behaviour in deep sleep.
+ * @{
+ */
+
+/**
+ * \defgroup hal_sleep_tests sleep hal tests
+ * The sleep HAL tests ensure driver conformance to defined behaviour.
+ *
+ * To run the sleep hal tests use the command:
+ *
+ *     mbed test -t <toolchain> -m <target> -n tests-mbed_hal-sleep*
+ *
+ */
+
+/** Send the microcontroller to sleep
+ *
+ * The processor is setup ready for sleep, and sent to sleep. In this mode, the
+ * system clock to the core is stopped until a reset or an interrupt occurs. This eliminates
+ * dynamic power used by the processor, memory systems and buses. The processor, peripheral and
+ * memory state are maintained, and the peripherals continue to work and can generate interrupts.
+ *
+ * The processor can be woken up by any internal peripheral interrupt or external pin interrupt.
+ *
+ * The wake-up time shall be less than 10 us.
+ *
+ */
+void hal_sleep(void);
+
+/** Send the microcontroller to deep sleep
+ *
+ * This processor is setup ready for deep sleep, and sent to sleep using __WFI(). This mode
+ * has the same sleep features as sleep plus it powers down peripherals and high frequency clocks.
+ * All state is still maintained.
+ *
+ * The processor can only be woken up by low power ticker, RTC, an external interrupt on a pin or a watchdog timer.
+ *
+ * The wake-up time shall be less than 10 ms.
+ */
+void hal_deepsleep(void);
+
+/**@}*/
+
+#ifdef __cplusplus
+}
+#endif
+
+#endif
+
+#endif
+
+/**@}*/