File content as of revision 592:a274ee790e56:

/**
 * \page asfdoc_sam0_system_pinmux_basic_use_case Quick Start Guide for SYSTEM PINMUX - Basic
 *
 * In this use case, the PINMUX module is configured for:
 *  \li One pin in input mode, with pull-up enabled, connected to the GPIO
 *      module
 *  \li Sampling mode of the pin changed to sample on demand
 *
 * This use case sets up the PINMUX to configure a physical I/O pin set as
 * an input with pull-up and changes the sampling mode of the pin to reduce
 * power by only sampling the physical pin state when the user application
 * attempts to read it.
 *
 * \section asfdoc_sam0_system_pinmux_basic_use_case_setup Setup
 *
 * \subsection asfdoc_sam0_system_pinmux_basic_use_case_setup_prereq Prerequisites
 * There are no special setup requirements for this use-case.
 *
 * \subsection asfdoc_sam0_system_pinmux_basic_use_case_setup_code Code
 * Copy-paste the following setup code to your application:
 * \snippet qs_pinmux_basic.c setup
 *
 * \subsection asfdoc_sam0_system_pinmux_basic_use_case_setup_flow Workflow
 * -# Create a PINMUX module pin configuration struct, which can be filled out
 *    to adjust the configuration of a single port pin.
 *    \snippet qs_pinmux_basic.c pinmux_config
 * -# Initialize the pin configuration struct with the module's default values.
 *    \snippet qs_pinmux_basic.c pinmux_config_defaults
 *    \note This should always be performed before using the configuration
 *          struct to ensure that all values are initialized to known default
 *          settings.
 *
 * -# Adjust the configuration struct to request an input pin with pullup
 *    connected to the GPIO peripheral.
 *  \snippet qs_pinmux_basic.c pinmux_update_config_values
 * -# Configure GPIO10 with the initialized pin configuration struct, to enable
 *    the input sampler on the pin.
 *    \snippet qs_pinmux_basic.c pinmux_set_config
 *
 * \section asfdoc_sam0_system_pinmux_basic_use_case_use_main Use Case
 *
 * \subsection asfdoc_sam0_system_pinmux_basic_use_case_code Code
 * Copy-paste the following code to your user application:
 * \snippet qs_pinmux_basic.c main
 *
 * \subsection asfdoc_sam0_system_pinmux_basic_use_case_flow Workflow

 * -# Adjust the configuration of the pin to enable on-demand sampling mode.
 *    \snippet qs_pinmux_basic.c pinmux_change_input_sampling
 */
/**
* Support and FAQ: visit <a href="http://www.atmel.com/design-support/">Atmel Support</a>
*/