File content as of revision 8:f784df013169:

/* mbed Microcontroller Library
 * Copyright (c) 2006-2013 ARM Limited
 *
 * Licensed under the Apache License, Version 2.0 (the "License");
 * you may not use this file except in compliance with the License.
 * You may obtain a copy of the License at
 *
 *     http://www.apache.org/licenses/LICENSE-2.0
 *
 * Unless required by applicable law or agreed to in writing, software
 * distributed under the License is distributed on an "AS IS" BASIS,
 * WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
 * See the License for the specific language governing permissions and
 * limitations under the License.
 */
#include "mbed.h"
#include "cc3000.h"
#include "main.h"

using namespace mbed_cc3000;

/* cc3000 module declaration specific for user's board. Check also init() */
#if (MY_BOARD == WIGO)
cc3000 wifi(PTA16, PTA13, PTD0, SPI(PTD2, PTD3, PTC5), "ssid", "key", WPA2, false);
Serial pc(USBTX, USBRX);
#elif (MY_BOARD == WIFI_DIPCORTEX)
cc3000 wifi(p28, p27, p30, SPI(p21, p14, p37), "ssid", "key", WPA2, false);
Serial pc(UART_TX, UART_RX);
#elif (MY_BOARD == MBED_BOARD_EXAMPLE)
cc3000 wifi(p9, p10, p8, SPI(p5, p6, p7), "ssid", "key", WPA2, false);
Serial pc(USBTX, USBRX);
#elif (MY_BOARD == SPARKFUN_WIFI_SHIELD)
cc3000 wifi(D2, D7, D10, SPI(D11, D12, D13), "ssid", "key", WPA2, false); //SparkFun Board on Arduino pin definitions
Serial pc(USBTX, USBRX);
#endif

/**
 *  \brief Hello World
 *  \param none
 *  \return int
 */
int main() {
    init(); /* board dependent init */
    pc.baud(9600);

    printf("cc3000 Hello World demo. \r\n");
    wifi.init();
    if (wifi.connect() == -1) {
        printf("Failed to connect. Please verify connection details and try again. \r\n");
    } else {
        printf("IP address: %s \r\n",wifi.getIPAddress());
        printf("\r\ncc3000 connected to the Internet. Demo completed. \r\n");
    }

    wifi.disconnect();
}