Diff: main.cpp

Revision:

1:cd5247f3a499

Parent:

0:f58f38896cfa

Child:

2:f131a1777c54

Child:

3:30be02620bad

--- a/main.cpp	Fri Sep 09 22:14:06 2016 +0000
+++ b/main.cpp	Sun Sep 11 22:24:03 2016 +0000
@@ -3,18 +3,22 @@
 #include "MCP23S17.h"
 
 // 1
-DigitalIn dip_switch8(p21);
-DigitalOut green_led(p22);
+DigitalIn dip_switch3(p30);
+DigitalOut red_led(p17);
 // 2
-DigitalIn dip_switch1(p26);
-DigitalIn dip_switch2(p25);
-PwmOut blue_led(p23);
+DigitalIn dip_switch1(p28);
+DigitalIn dip_switch2(p29);
+PwmOut green_led(p21);
 // 3
 SPI spi(p5, p6, p7); // SPI bus
 char Opcode = 0x40; // 8-bit address for writes
 MCP23S17 chip = MCP23S17(spi, p20, Opcode); // create an MCP23S17
-
 int switch_state;
+// Analog control
+AnalogIn control_pot(p18);
+PwmOut rgb_b(p22);
+PwmOut rgb_r(p23);
+PwmOut rgb_g(p24);
 
 int main()
 {
@@ -22,8 +26,8 @@
     dip_switch1.mode(PullUp); // configure internal pull up resistor
     dip_switch2.mode(PullUp);
     
-    blue_led.period(0.016f); // ~ 60 Hz
-    blue_led.write(0.50f); // 50 % duty cycle
+    green_led.period(0.016f); // ~ 60 Hz
+    green_led.write(0.50f); // 50 % duty cycle
     
     // 3
     chip.direction(PORT_A, 0x00); // set all Port A bits to output
@@ -32,16 +36,16 @@
     
     while(1) {
         // 1
-        green_led = dip_switch8;
+        red_led = dip_switch3;
         
         // 2
         if (!dip_switch1) {
-            blue_led.write(0.25f); // half start brightness, half duty cycle
+            green_led.write(0.25f); // half start brightness, half duty cycle
         }
         else if (!dip_switch2) {
-            blue_led.write(0.125f); // 1/4 starting brightness
+            green_led.write(0.125f); // 1/4 starting brightness
         } else {
-            blue_led.write(0.50f); // initial
+            green_led.write(0.50f); // initial
         }
         
         // 3
@@ -51,5 +55,10 @@
         chip.write(PORT_A, switch_state);
         wait(.2);
         // yellow led should change opposite the green led
+        
+        // Analog control
+        rgb_r = control_pot;
+        rgb_g = 0.5f - control_pot;
+        rgb_b = 1.0f - control_pot;
     }
 }