This is the SparkFun_VL53L1X_Arduino_Library translated into mbed, with some elements of Ian Kilburn's VL6180x mbed library.
Dependents: Hug2Go_ver_2 Nucleo_rtos_basic_f103rb
VL53L1X.h
- Committer:
- jvfausto
- Date:
- 2018-07-19
- Revision:
- 1:0d762892f7af
- Parent:
- 0:03b7e8deb3ee
- Child:
- 5:aa8cc9e87216
File content as of revision 1:0d762892f7af:
#ifndef VL53L1X_H #define VL53L1X_H #include "mbed.h" #include "VL53L1X_register_map.h" #define I2C_BUFFER_LENGTH 32 const char defaultAddress_VL53L1X = 0x29; class VL53L1X { public: VL53L1X(PinName SDA, PinName SCL); bool begin(); void softReset(); //Reset the sensor via software void startMeasurement(uint8_t offset = 0); //Write a block of bytes to the sensor to configure it to take a measurement bool newDataReady(); //Polls the measurement completion bit uint16_t getDistance(); //Returns the results from the last measurement, distance in mm uint16_t getSignalRate(); //Returns the results from the last measurement, signal rate void setDistanceMode(uint8_t mode = 2);//Defaults to long range uint8_t getDistanceMode(); uint8_t getRangeStatus(); //Returns the results from the last measurement, 0 = valid uint8_t readRegister(uint16_t addr); //Read a byte from a 16-bit address uint16_t readRegister16(uint16_t addr); //Read two bytes from a 16-bit address void writeRegister(uint16_t addr, uint8_t val); //Write a byte to a spot void writeRegister16(uint16_t addr, uint16_t val); //Write two bytes to a spot private: I2C _i2c; uint8_t _deviceAddress; uint8_t _distanceMode;// = 0; <--- might cause a problem }; #endif