TTP229 16key touch keypad
This library support only 16key mode and active low mode
jamper set TP1=1(default) and TP2=0(jamper close).
pin connection
mbed TTP229 GPIO(InterruptIn) --------------- SDO GPIO(DigitalOut) --------------- SCL 3.3V --------------- VCC GND --------------- GND
sample program is here.
アマゾンで購入したTTP229 を使った16キーのタッチキーパッドを使うためのライブラリです。
このボードは8keyモードにも設定できますが、このライブラリは16キーモード専用です
16キーモードに設定するには TP2を高抵抗でGNDに繋ぎます。私が入手したボードではジャンパ設定の3番をクローズにすればこの状態になります。
TP1で active low と active highの切替が出来ますが、このライブラリは active lowを想定していますので、TP1はデフォルトのまま(GNDには繋がない)にしてください。その他のジャンパは使用目的に応じて自由に設定して構いません。
詳しくはこちらをご覧ください。
TTP229.h
- Committer:
- jk1lot
- Date:
- 2016-07-16
- Revision:
- 0:50226acdb872
- Child:
- 1:c20148b5c68e
File content as of revision 0:50226acdb872:
#ifndef TTP229_H #define TTP229_H #include "mbed.h" #include <bitset> /** 16key touch keypad\n * Only supported 16key and active low mode\n * jamper settng : TP1=1(jamper2=open):active low, TP2=0(jamper3=close):16key mode\n */ class TTP229 { public: ///@param sdopin PinName that support DigitalIn and InterruptIn, connected to TTP229 SDO. ///@param sclpin PinName that support DigitalOut, connected to TTP229 SCL. TTP229(PinName sdopin, PinName sclpin); ///set function that is called at change state of keypad void attach(const FunctionPointer& fp) {callback=fp;} ///get keypad status bitset<16> getkeys() {return sw;} ///same as getkeys() operator bitset<16>() {return getkeys();} ///get keypad status especially singlekey mode(TP3=1,TP4=1) ///@return touched keypad number(1~16) or 0:no keypad touched int onkey() {return swnum;} ///Is number i(0~15) keypad touched? bool ison(size_t i) {return getkeys()[i];} ///same as ison() bool operator[](size_t i) {return ison(i);} protected: void interrupt(); private: DigitalIn sdo; InterruptIn sdoInt; DigitalOut scl; FunctionPointer callback; bitset<16> sw; int swnum; }; #endif