nRF24L01 driver
Dependents: Nucleo_IOT1 wireless
Diff: nRF24L01P.h
- Revision:
- 4:8f612189af31
- Parent:
- 2:75a1c2139f17
- Child:
- 6:952996e3abdb
--- a/nRF24L01P.h Fri Sep 02 15:51:22 2016 +0000 +++ b/nRF24L01P.h Sat Sep 03 12:24:04 2016 +0000 @@ -47,7 +47,7 @@ // set the RF channel, 0 .. 125. // The frequency in MHz is 2400 + Channel. // In 2Mbps mode, you must use channels at least 2MHz appart to avoid overlap - // DEFAULT: + // DEFAULT: channel 2 void set_channel(int Channel); // PRECONDITION: Mode = Receive. True if a signal higher than -64bB is detected by the receiver @@ -59,11 +59,11 @@ // enable or disable dynamic payload size on the given pipe - // DEFAULT: + // DEFAULT: false void enable_dynamic_payload(int Pipe, bool Enable); // Enable including a payload with ACK - // DEFAULT: + // DEFAULT: false void enable_ack_payload(bool Enable); // enable the write_tx_payload_no_ack() command @@ -138,11 +138,11 @@ // set the auto-retransmit delay, in units of 250 microseconds. // Valid input is 0,1,...,15 (for 250 .. 4000 us) - // DEFAULT: + // DEFAULT: 0 (250us) void set_retransmit_delay(int Delay); // set the number of auto-retransmit attempts, 0 .. 15 - // DEFAULT: + // DEFAULT: 3 void set_retransmit_attempts(int Attempts); // returns true if we've hit the maximum number of restransmits @@ -156,11 +156,11 @@ void set_interrupt_max_rt(bool Enable); // enable or disable the CRC check. Auto-acknowledge forces CRC enabled. - // DEFAULT: + // DEFAULT: true void enable_crc(bool Enable); // set the CRC width, either 1 byte or 2 bytes - // DEFAULT: + // DEFAULT: 1 byte void set_crc_width(int width); // set PWR_UP (move into standby mode) @@ -198,7 +198,7 @@ // Set the tx address. Used only for a PTX, set this the same as the rx_address of pipe 0 to enable // auto-acknowledge with Enhanced ShockBurst(TM) - // DEFAULT: + // DEFAULT: 0xE7E7E7E7E void set_tx_address(uint64_t Address); // commands