Libery for HX711 sensor. This is for measureing the weigth of the keg
Diff: Hx711.h
- Revision:
- 0:52c805a049c4
--- /dev/null Thu Jan 01 00:00:00 1970 +0000 +++ b/Hx711.h Sun Feb 21 11:01:00 2016 +0000 @@ -0,0 +1,62 @@ +#ifndef HX711_h +#define HX711_h +//Translatet module from arduino to mbed https://codebender.cc/library/HX711#HX711.h + +#include "mbed.h" + +class HX711 +{ + private: + DigitalOut _pin_slk; // Power Down and Serial Clock Input Pin + DigitalIn _pin_dout; // Serial Data Output Pin + char GAIN; // amplification factor + long OFFSET; // used for tare weight + float SCALE; // used to return weight in grams, kg, ounces, whatever + public: + // define clock and data pin, channel, and gain factor + // channel selection is made by passing the appropriate gain: 128 or 64 for channel A, 32 for channel B + // gain: 128 or 64 for channel A; channel B works with 32 gain factor only + HX711(PinName pin_dout, PinName pin_slk); + + virtual ~HX711(); + + // check if HX711 is ready + // from the datasheet: When output data is not ready for retrieval, digital output pin DOUT is high. Serial clock + // input PD_SCK should be low. When DOUT goes to low, it indicates data is ready for retrieval. + + + // set the gain factor; takes effect only after a call to read() + // channel A can be set for a 128 or 64 gain; channel B has a fixed 32 gain + // depending on the parameter, the channel is also set to either A or B + void set_gain(char gain = 128); + + // waits for the chip to be ready and returns a reading + long read(); + + // returns an average reading; times = how many times to read + long read_average(char times = 10); + + // returns (read_average() - OFFSET), that is the current value without the tare weight; times = how many readings to do + double get_value(char times = 1); + + // returns get_value() divided by SCALE, that is the raw value divided by a value obtained via calibration + // times = how many readings to do + float get_units(char times = 1); + + // set the OFFSET value for tare weight; times = how many times to read the tare value + void tare(char times = 10); + + // set the SCALE value; this value is used to convert the raw data to "human readable" data (measure units) + void set_scale(float scale = 1.f); + + // set OFFSET, the value that's subtracted from the actual reading (tare weight) + void set_offset(long offset = 0); + + // puts the chip into power down mode + void power_down(); + + // wakes up the chip after power down mode + void power_up(); +}; + +#endif /* HX711_h */ \ No newline at end of file