Diff: config_me.h

Revision:

46:69966d555de7

Parent:

45:fe90f1fcb4e0

--- a/config_me.h	Wed Nov 30 14:50:16 2016 +0000
+++ /dev/null	Thu Jan 01 00:00:00 1970 +0000
@@ -1,47 +0,0 @@
-#ifndef __CONFIG_ME_H_
-#define __CONFIG_ME_H_
-
-// User must set these for own context:
-
-// This is the server's base URL name.  Example "www.google.com"
-// Note that when you Fork a FLOW, it will typically assign  either
-// "run-east.att.io" or "run-west.att.io", so be sure to check this.
-static const char * MY_SERVER_URL       = "run-east.att.io";
-
-// These are FLOW fields from the Endpoints tab:
-#define FLOW_BASE_URL                   "/a80556051c438/f4cd2ed65f73/7ecb40fcd115f7a/in/flow"
-#define FLOW_INPUT_NAME                 "/shelf"
-//#define FLOW_BASE_URL                   "/d87b3ed23c5ca/93177ca6df10/cf972daf89febc2/in/flow"
-//#define FLOW_INPUT_NAME                 "/car"
-// Unless you want to use a different protocol, this field should be left as is:
-#define FLOW_URL_TYPE                   " HTTP/1.1\r\nHost: "
-
-// This identifier specifies with which FLOW device you are communicating. 
-// If you only have one devive there then you can just leave this as is.
-// Once your FLOW device has been initialized (Virtual Device Initialize clicked),
-// the Virtual Device will show up in M2X.  This is its "DEVICE SERIAL" field
-#define FLOW_DEVICE_NAME                "vstarterkit001"
-
-// This constant defines how often sensors are read and sent up to FLOW
-#define SENSOR_UPDATE_INTERVAL_MS       5000; //5 seconds
-
-// Specify here how many sensor parameters you want reported to FLOW.
-// You can use only the temperature and humidity from the shield HTS221
-// or you can add the reading of the FXO8700CQ motion sensor on the FRDM-K64F board
-// or if you have a SiLabs PMOD plugged into the shield, you can add its proximity sensor,
-// UV light, visible ambient light and infrared ambient light readings
-#define TEMP_HUMIDITY_ONLY                      1
-#define TEMP_HUMIDITY_ACCELEROMETER             2
-#define TEMP_HUMIDITY_ACCELEROMETER_PMODSENSORS 3
-#define PROXIMITY_ONLY 4
-#define SWITCH_ONLY 5
-static int iSensorsToReport = PROXIMITY_ONLY; //TEMP_HUMIDITY_ONLY; //modify this to change your selection
-
-// This is the APN name for the cellular network, you will need to change this, check the instructions included with your SIM card kit:
-//#define  MY_APN_STR  "m2m.com.attz"
-#define  MY_APN_STR  "attiotdemo"
-//#define  MY_APN_STR  "nxtgenphone"
-//This is for normal HTTP.  If you want to use TCP to a specific port, change that here:
-static int MY_PORT         = 80;
-
-#endif