Tyler Sisk
Library to interface to the TI BQ27441, a fuel gauge monitor
Fork of
battery-gauge-bq27441
by 
u-blox
History
Fixes current = 0 problem and adds power measurement capability
2017-12-13, by breadboardbasics [Wed, 13 Dec 2017 17:14:51 +0000] rev 6
Fixes current = 0 problem and adds power measurement capability
Add ability to enable/disable battery detection and make sure that it is switched off when the tests are run on the u-blox C030 platform (since the BIN pin is not connected).
2017-06-14, by rob.meades@u-blox.com [Wed, 14 Jun 2017 17:11:40 +0100] rev 5
Add ability to enable/disable battery detection and make sure that it is switched off when the tests are run on the u-blox C030 platform (since the BIN pin is not connected).
Add datasheets.
2017-06-07, by RobMeades [Wed, 07 Jun 2017 10:32:54 +0000] rev 4
Add datasheets.
Add API to check if battery gauging is enabled. Remove old UTM board pin-outs. Remove unused Doxyfile.
2017-06-06, by rob.meades@u-blox.com [Tue, 06 Jun 2017 15:58:21 +0100] rev 3
Add API to check if battery gauging is enabled. Remove old UTM board pin-outs. Remove unused Doxyfile.
Change Doxygen comment format to match mbed on-line IDE's somewhat restrictive expectations.
2017-04-11, by RobMeades [Tue, 11 Apr 2017 09:57:10 +0000] rev 2
Change Doxygen comment format to match mbed on-line IDE's somewhat restrictive expectations.
Add files to repo, removing temp.txt placeholder.
2017-04-10, by rob.meades@u-blox.com [Mon, 10 Apr 2017 11:18:51 +0100] rev 1
Add files to repo, removing temp.txt placeholder.
Create repo for TI BQ27441 battery gauge chip.
2017-04-10, by RobMeades [Mon, 10 Apr 2017 10:11:59 +0000] rev 0
Create repo for TI BQ27441 battery gauge chip.