t
Fork of mbed-dev by
targets/TARGET_Silicon_Labs/TARGET_EFM32/TARGET_EFM32GG/TARGET_EFM32GG_STK3700/PinNames.h
- Committer:
- <>
- Date:
- 2016-11-08
- Revision:
- 150:02e0a0aed4ec
- Child:
- 153:fa9ff456f731
File content as of revision 150:02e0a0aed4ec:
/***************************************************************************//** * @file PinNames.h ******************************************************************************* * @section License * <b>(C) Copyright 2015 Silicon Labs, http://www.silabs.com</b> ******************************************************************************* * * SPDX-License-Identifier: Apache-2.0 * * Licensed under the Apache License, Version 2.0 (the "License"); you may * not use this file except in compliance with the License. * You may obtain a copy of the License at * * http://www.apache.org/licenses/LICENSE-2.0 * * Unless required by applicable law or agreed to in writing, software * distributed under the License is distributed on an "AS IS" BASIS, WITHOUT * WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied. * See the License for the specific language governing permissions and * limitations under the License. * ******************************************************************************/ #ifndef MBED_PINNAMES_H #define MBED_PINNAMES_H #include "CommonPinNames.h" #ifdef __cplusplus extern "C" { #endif typedef enum { EFM32_STANDARD_PIN_DEFINITIONS, /* Starter Kit says LED0 and LED1, but mbed expects 1 and 2. This way using 1 and 2 or 0 and 1 will work. */ LED0 = PE2, LED1 = PE3, LED2 = LED0, LED3 = LED0, LED4 = LED1, /* Push Buttons */ SW0 = PB9, SW1 = PB10, BTN0 = SW0, BTN1 = SW1, /* Serial */ SERIAL_TX = PD0, SERIAL_RX = PD1, USBTX = PE0, USBRX = PE1, /* Board Controller */ STDIO_UART_TX = USBTX, STDIO_UART_RX = USBRX, EFM_BC_EN = PF7 } PinName; #ifdef __cplusplus } #endif #endif