Activity
Reply to
I2C freeze
- hi guys, I meet the same problem now. i use mbed to control ESC BL-Ctrl …
- 29 Oct 2011
Reply to
i2c port dead
- Wim Huiskamp wrote: What is an 'ESC' module? References, datasheets would help.. Anyhow, the ESC …
- 16 Sep 2011
Reply to
i2c port dead
- Should I use a level shifter or converter? If yes. Okay then. Can my mbed …
- 16 Sep 2011
New topic
i2c port dead
- Dear Support Team, I have bad experience, I use i2c protocol to control some ESC-i2cs. …
- 16 Sep 2011
Program:
Mini-X
- 16 Aug 2011
New topic
i2c frequency: dear all, i have a simple question. what is the default frequency of the i2c? …
- 26 Oct 2010
Reply to
ADC Value
- Thanks Thomas and Jon for your info, it really helps. My Senscom mini-A ultrasonic sensor …
- 23 Aug 2010
Reply to
ADC Value
- And... how to reduce the noise?
- 23 Aug 2010
New topic
ADC Value: Dear forum, I try to read 3.3V regulated power source by the AnalogIn (p19). I …
- 23 Aug 2010
New topic
why so slow?? (again): Dear guys, I found another bad news during my prototyping comparing the mbed with my …
- 17 Aug 2010
Reply to
read PPM signal
- Yup, finally to guarantee the PPM reading always correct I only use one interrupt (raising …
- 13 Aug 2010
Reply to
heat and power
- After I changed the power input from >5battery (:several batt.s) to 5V regulated, shut down …
- 13 Aug 2010
Reply to
NXP LPC1768 looks so slow (?)
- Thank you sir, But as shown in this 2 previous replies: even-tough I deactivate the …
- 12 Aug 2010
New topic
heat and power: Dear forum, I have another problem now, my mbed-uC is really easy being heat after …
- 12 Aug 2010
Reply to
read PPM signal
- the code are here: http://mbed.org/users/agiembed/programs/Controller/5zsla and this is the wiring:
- 12 Aug 2010
Program:
Controller
- 12 Aug 2010
Reply to
NXP LPC1768 looks so slow (?)
- Thank you sir, but sorry i forgot to '//' that. Actually when I compile it …
- 11 Aug 2010
Reply to
read PPM signal
- I try to read the PPM signal only using rising interrupt to reduce ISR number. …
- 11 Aug 2010