Diff: doc/csv/error_codes_en_US.csv
- Revision:
- 0:8f0d870509fe
--- /dev/null Thu Jan 01 00:00:00 1970 +0000 +++ b/doc/csv/error_codes_en_US.csv Mon Sep 04 12:04:13 2017 +0000 @@ -0,0 +1,37 @@ +Error Code in v1.1+ ,Error Message in v1.0-, Error Description +1,Expected command letter,G-code words consist of a letter and a value. Letter was not found. +2,Bad number format,Missing the expected G-code word value or numeric value format is not valid. +3,Invalid statement,Grbl '$' system command was not recognized or supported. +4,Value < 0,Negative value received for an expected positive value. +5,Setting disabled,Homing cycle failure. Homing is not enabled via settings. +6,Value < 3 usec,Minimum step pulse time must be greater than 3usec. +7,EEPROM read fail. Using defaults,An EEPROM read failed. Auto-restoring affected EEPROM to default values. +8,Not idle,Grbl '$' command cannot be used unless Grbl is IDLE. Ensures smooth operation during a job. +9,G-code lock,G-code commands are locked out during alarm or jog state. +10,Homing not enabled,Soft limits cannot be enabled without homing also enabled. +11,Line overflow,Max characters per line exceeded. Received command line was not executed. +12,Step rate > 30kHz,Grbl '$' setting value cause the step rate to exceed the maximum supported. +13,Check Door,Safety door detected as opened and door state initiated. +14,Line length exceeded,Build info or startup line exceeded EEPROM line length limit. Line not stored. +15,Travel exceeded,Jog target exceeds machine travel. Jog command has been ignored. +16,Invalid jog command,Jog command has no '=' or contains prohibited g-code. +17,Setting disabled,Laser mode requires PWM output. +20,Unsupported command,Unsupported or invalid g-code command found in block. +21,Modal group violation,More than one g-code command from same modal group found in block. +22,Undefined feed rate,Feed rate has not yet been set or is undefined. +23,Invalid gcode ID:23,G-code command in block requires an integer value. +24,Invalid gcode ID:24,More than one g-code command that requires axis words found in block. +25,Invalid gcode ID:25,Repeated g-code word found in block. +26,Invalid gcode ID:26,No axis words found in block for g-code command or current modal state which requires them. +27,Invalid gcode ID:27,Line number value is invalid. +28,Invalid gcode ID:28,G-code command is missing a required value word. +29,Invalid gcode ID:29,G59.x work coordinate systems are not supported. +30,Invalid gcode ID:30,G53 only allowed with G0 and G1 motion modes. +31,Invalid gcode ID:31,Axis words found in block when no command or current modal state uses them. +32,Invalid gcode ID:32,G2 and G3 arcs require at least one in-plane axis word. +33,Invalid gcode ID:33,Motion command target is invalid. +34,Invalid gcode ID:34,Arc radius value is invalid. +35,Invalid gcode ID:35,G2 and G3 arcs require at least one in-plane offset word. +36,Invalid gcode ID:36,Unused value words found in block. +37,Invalid gcode ID:37,G43.1 dynamic tool length offset is not assigned to configured tool length axis. +38,Invalid gcode ID:38,Tool number greater than max supported value. \ No newline at end of file