File content as of revision 4:28533c0e8527:

#include "mbed.h"
// Sensors drivers present in the BSP library
#include "stm32l475e_iot01_tsensor.h"
#include "stm32l475e_iot01_hsensor.h"
#include "stm32l475e_iot01_psensor.h"
#include "stm32l475e_iot01_magneto.h"
#include "stm32l475e_iot01_gyro.h"
#include "stm32l475e_iot01_accelero.h"

DigitalOut led(LED1);
   
int main()
{
    float sensor_value = 0;
    int16_t pDataXYZ[3] = {0};
    float pGyroDataXYZ[3] = {0};

    printf("Start sensor init\n");
     
    BSP_TSENSOR_Init();
    BSP_HSENSOR_Init();

    
    BSP_PSENSOR_Init();

    BSP_MAGNETO_Init();
    BSP_GYRO_Init();
    BSP_ACCELERO_Init();

    while(1) {
        printf("\nNew loop, LED1 should blink during sensor read\n");
      

        led = 1;

        sensor_value = BSP_TSENSOR_ReadTemp();
        printf("\n温度 = %.2f degC\n", sensor_value);

        sensor_value = BSP_HSENSOR_ReadHumidity();
        printf("湿度    = %.2f %%\n", sensor_value);

        sensor_value = BSP_PSENSOR_ReadPressure();
        printf("压力  is = %.2f mBar\n", sensor_value);

        led = 0;

        ThisThread::sleep_for(1000);

        led = 1;

        BSP_MAGNETO_GetXYZ(pDataXYZ);
        printf("\nMAGNETO_X = %d\n", pDataXYZ[0]);
        printf("MAGNETO_Y = %d\n", pDataXYZ[1]);
        printf("MAGNETO_Z = %d\n", pDataXYZ[2]);

        BSP_GYRO_GetXYZ(pGyroDataXYZ);
        printf("\nGYRO_X = %.2f\n", pGyroDataXYZ[0]);
        printf("GYRO_Y = %.2f\n", pGyroDataXYZ[1]);
        printf("GYRO_Z = %.2f\n", pGyroDataXYZ[2]);

        BSP_ACCELERO_AccGetXYZ(pDataXYZ);
        printf("\nACCELERO_X = %d\n", pDataXYZ[0]);
        printf("ACCELERO_Y = %d\n", pDataXYZ[1]);
        printf("ACCELERO_Z = %d\n", pDataXYZ[2]);

        led = 0;

        ThisThread::sleep_for(1000);

    }
}