Driver for the ESP8266 WiFi module using ATParser library. Espressif Firmware.

Dependencies:   ATParser

Dependents:   ESP8266Interface

Fork of ESP8266 by NetworkSocketAPI

Note

This library assumes your ESP8266 is running the Espressif Firmware. For instructions on how to update your ESP8266 to use the correct firmware see the Firmware Update Wiki Page.

ESP8266.cpp

Committer:
Christopher Haster
Date:
2016-02-18
Revision:
18:11f2f6bd2e97
Parent:
17:8b541b19f391
Child:
20:32e5a5a328e0

File content as of revision 18:11f2f6bd2e97:

/* ESP8266 Example
 * Copyright (c) 2015 ARM Limited
 *
 * Licensed under the Apache License, Version 2.0 (the "License");
 * you may not use this file except in compliance with the License.
 * You may obtain a copy of the License at
 *
 *     http://www.apache.org/licenses/LICENSE-2.0
 *
 * Unless required by applicable law or agreed to in writing, software
 * distributed under the License is distributed on an "AS IS" BASIS,
 * WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
 * See the License for the specific language governing permissions and
 * limitations under the License.
 */

#include "ESP8266.h"

ESP8266::ESP8266(PinName tx, PinName rx, bool debug)
    : _serial(tx, rx, 1024), _parser(_serial)
{
    _serial.baud(115200);
    _parser.debugOn(debug);
}

bool ESP8266::startup(int mode)
{
    //only 3 valid modes
    if(mode < 1 || mode > 3) {
        return false;
    }

    return reset()
        && _parser.send("AT+CWMODE=%d", mode) 
        && _parser.recv("OK")
        && _parser.send("AT+CIPMUX=1") 
        && _parser.recv("OK");
}

bool ESP8266::reset(void)
{
    return _parser.send("AT+RST")
        && _parser.recv("OK\r\nready");
}

bool ESP8266::dhcp(bool enabled, int mode)
{
    //only 3 valid modes
    if(mode < 0 || mode > 2) {
        return false;
    }

    return _parser.send("AT+CWDHCP=%d,%d", enabled?1:0, mode)
        && _parser.recv("OK");
}

bool ESP8266::connect(const char *ap, const char *passPhrase)
{
    return _parser.send("AT+CWJAP=\"%s\",\"%s\"", ap, passPhrase)
        && _parser.recv("OK");
}

bool ESP8266::disconnect(void)
{
    return _parser.send("AT+CWQAP") && _parser.recv("OK");
}

const char *ESP8266::getIPAddress(void)
{
    if (!(_parser.send("AT+CIFSR")
        && _parser.recv("+CIFSR:STAIP,\"%[^\"]\"", _ip_buffer)
        && _parser.recv("OK"))) {
        return 0;
    }

    return _ip_buffer;
}

const char *ESP8266::getMACAddress(void)
{
    if (!(_parser.send("AT+CIFSR")
        && _parser.recv("+CIFSR:STAMAC,\"%[^\"]\"", _mac_buffer)
        && _parser.recv("OK"))) {
        return 0;
    }

    return _mac_buffer;
}

bool ESP8266::isConnected(void)
{
    return getIPAddress() != 0;
}

bool ESP8266::open(const char *type, int id, const char* addr, int port)
{
    //IDs only 0-4
    if(id > 4) {
        return false;
    }

    return _parser.send("AT+CIPSTART=%d,\"%s\",\"%s\",%d", id, type, addr, port)
        && _parser.recv("OK");
}

bool ESP8266::send(int id, const void *data, uint32_t amount)
{
    //May take a second try if device is busy
    for (unsigned i = 0; i < 2; i++) {
        if (_parser.send("AT+CIPSEND=%d,%d", id, amount)
            && _parser.recv(">")
            && _parser.write((char*)data, (int)amount) >= 0) {
            return true;
        }
    }

    return false;
}

int32_t ESP8266::recv(int id, void *data, uint32_t amount)
{
    uint32_t recv_amount;
    int recv_id;

    if (!(_parser.recv("+IPD,%d,%d:", &recv_id, &recv_amount)
        && recv_id == id
        && recv_amount <= amount
        && _parser.read((char*)data, recv_amount)
        && _parser.recv("OK"))) {
        return -1;
    }

    return recv_amount;
}

bool ESP8266::close(int id)
{
    //IDs only 0-4
    if(id > 4) {
        return false;
    }

    return _parser.send("AT+CIPCLOSE=%d", id)
        && _parser.recv("OK");
}

void ESP8266::setTimeout(uint32_t timeout_ms)
{
    _parser.setTimeout(timeout_ms);
}

bool ESP8266::readable()
{
    return _serial.readable();
}

bool ESP8266::writeable()
{
    return _serial.writeable();
}