WIZnet / Mbed 2 deprecated PIR_Motion_Sensor_WIZwiki-W7500

Use to WIZwiki-W7500, Sensing to PIR motion sensor module(HC-SR501)

Dependencies:   mbed

Fork of PIR_Motion_Sensor_WIZwiki-W7500 by Scott Jeong

You are viewing an older revision! See the latest version

Homepage

Table of Contents

  1. Prerequisite
  2. Hardware Configuration
  3. Software
  4. Caution

Prerequisite

This example is for PIR test using digital I/O.

To implement this function, you need a Platform board, network Interface board.

  • WIZwiki-W7500 from WIZnet (Platform board and Ethernet I/F board)

Hardware Configuration

WIZwiki-W7500 Pin map

pin map

PIR Sensor(HC-501SR) Pin map

pin map

Wiring Table

HC-501SRW7500
VCC5V
GNDGND
SIGNALD8

Software

Init GPIO

DigitalOut myled(LED1); // Alert LED
DigitalIn PIR(D8); // PIR Signal

Get data from PIR

    int PIR_sensor;   // declare variable for PIR input data
    while(1) {
        PIR_sensor = PIR; // Check input signal from PIR pin
        pc.printf("PIR Value : %d\r\n",PIR_sensor);
        myled =! PIR_sensor; // PIR(HIGH) == LED On // PIR(LOW) == LED Off
        wait(0.1f);
    }

Caution

When wiring, be careful (GND, VCC)

All wikipages