File content as of revision 1:245bc5eb1bbe:

#include "mbed.h"
/****************************************************************
In this exercise I would like you to make one function called "ToggleAll"
this function should switch the state of the led from its current state 
you can figure out the current state by typing "= led1;"
in this function I expect to see and minimal lines of code as possible

In the main function I expect to see the on and off functions replaced with this new one.

best of luck.
***************************************************************/

// these functions initializes the led pins and functions associated with them these are technically c++ but dont worry to much about this yet
DigitalOut led1(D5);
DigitalOut led2(D6);
DigitalOut led3(D7);
DigitalOut led4(D8);
DigitalOut led5(D9);
DigitalOut led6(D10);
DigitalOut led7(D11);
DigitalOut led8(D12);

// this is your main function and is where the code starts good luck!
int main() {

}