Software_Interrupt_Management
[EXTI Exported Functions]

Generate a software Interrupt Event for Lines in range 0 to 31.

Note:

If the interrupt is enabled on this line in the EXTI_IMR, writing a 1 to this bit when it is at '0' sets the corresponding pending bit in EXTI_PR resulting in an interrupt request generation. This bit is cleared by clearing the corresponding bit in the EXTI_PR register (by writing a 1 into the bit) SWIER1 SWIx LL_EXTI_GenerateSWI_0_31

Parameters:

ExtiLine

This parameter can be a combination of the following values: LL_EXTI_LINE_0 LL_EXTI_LINE_1 LL_EXTI_LINE_2 LL_EXTI_LINE_3 LL_EXTI_LINE_4 LL_EXTI_LINE_5 LL_EXTI_LINE_6 LL_EXTI_LINE_7 LL_EXTI_LINE_8 LL_EXTI_LINE_9 LL_EXTI_LINE_10 LL_EXTI_LINE_11 LL_EXTI_LINE_12 LL_EXTI_LINE_13 LL_EXTI_LINE_14 LL_EXTI_LINE_15 LL_EXTI_LINE_16 LL_EXTI_LINE_18 LL_EXTI_LINE_19 LL_EXTI_LINE_20 LL_EXTI_LINE_21 LL_EXTI_LINE_22 LL_EXTI_LINE_29 LL_EXTI_LINE_30 LL_EXTI_LINE_31

Note:

Please check each device line mapping for EXTI Line availability

Return values:

None

Definition at line 1104 of file stm32l4xx_ll_exti.h.

Generate a software Interrupt Event for Lines in range 32 to 63.

Note:

If the interrupt is enabled on this line inthe EXTI_IMR, writing a 1 to this bit when it is at '0' sets the corresponding pending bit in EXTI_PR resulting in an interrupt request generation. This bit is cleared by clearing the corresponding bit in the EXTI_PR register (by writing a 1 into the bit) SWIER2 SWIx LL_EXTI_GenerateSWI_32_63

Parameters:

ExtiLine

This parameter can be a combination of the following values: LL_EXTI_LINE_35 LL_EXTI_LINE_36 LL_EXTI_LINE_37 LL_EXTI_LINE_38

Return values:

None

Definition at line 1124 of file stm32l4xx_ll_exti.h.