Diff: sx1276/sx1276-hal.h

Revision:

26:d09a8ef807e2

Parent:

22:7f3aab69cca9

--- a/sx1276/sx1276-hal.h	Thu Nov 26 16:55:15 2015 +0000
+++ b/sx1276/sx1276-hal.h	Mon Apr 24 09:26:23 2017 +0000
@@ -17,15 +17,16 @@
 #include "sx1276.h"
 
 /*!
- * \brief Radio hardware registers initialization definition
+ * @brief Radio hardware registers initialization definition
  *
- * \remark Can be automatically generated by the SX1276 GUI (not yet implemented)
+ * @remark Can be automatically generated by the SX1276 GUI (not yet implemented)
  */
 #define RADIO_INIT_REGISTERS_VALUE                \
 {                                                 \
     { MODEM_FSK , REG_LNA                , 0x23 },\
     { MODEM_FSK , REG_RXCONFIG           , 0x1E },\
     { MODEM_FSK , REG_RSSICONFIG         , 0xD2 },\
+    { MODEM_FSK , REG_AFCFEI             , 0x01 },\
     { MODEM_FSK , REG_PREAMBLEDETECT     , 0xAA },\
     { MODEM_FSK , REG_OSC                , 0x07 },\
     { MODEM_FSK , REG_SYNCCONFIG         , 0x12 },\
@@ -49,29 +50,28 @@
     /*!
      * Antenna switch GPIO pins objects
      */
-    DigitalInOut antSwitch;
-    
-    DigitalIn fake;
-    
+    DigitalInOut AntSwitch;
+    DigitalIn Fake;
+
 private:
     static const RadioRegisters_t RadioRegsInit[];
-    
+
 public:
     SX1276MB1xAS( RadioEvents_t *events,
             PinName mosi, PinName miso, PinName sclk, PinName nss, PinName reset,
             PinName dio0, PinName dio1, PinName dio2, PinName dio3, PinName dio4, PinName dio5,
             PinName antSwitch ); 
-    
+
     SX1276MB1xAS( RadioEvents_t *events );
-    
+
     virtual ~SX1276MB1xAS( ) { };
-    
-    protected:
+
+protected:
     /*!
      * @brief Initializes the radio I/Os pins interface
      */
     virtual void IoInit( void );
-    
+
     /*!
      *  @brief Initializes the radio registers
      */
@@ -81,7 +81,7 @@
      * @brief Initializes the radio SPI
      */
     virtual void SpiInit( void );
-    
+
     /*!
      * @brief Initializes DIO IRQ handlers
      *
@@ -97,6 +97,13 @@
     virtual void IoDeInit( void );
 
     /*!
+     * \brief Sets the radio output power.
+     *
+     * @param [IN] power Sets the RF output power
+     */
+    virtual void SetRfTxPower( int8_t power );
+
+    /*!
      * @brief Gets the board PA selection configuration
      *
      * @param [IN] channel Channel frequency in Hz
@@ -119,25 +126,25 @@
     /*!
      * @brief De-initializes the RF Switch I/Os pins interface 
      *
-     * \remark Needed to decrease the power consumption in MCU lowpower modes
+     * @remark Needed to decrease the power consumption in MCU lowpower modes
      */
     virtual void AntSwDeInit( void );
 
     /*!
      * @brief Controls the antena switch if necessary.
      *
-     * \remark see errata note
+     * @remark see errata note
      *
-     * @param [IN] rxTx [1: Tx, 0: Rx]
+     * @param [IN] opMode Current radio operating mode
      */
-    virtual void SetAntSw( uint8_t rxTx );
-    
-    public:
+    virtual void SetAntSw( uint8_t opMode );
+
+public:
     /*!
      * @brief Detect the board connected by reading the value of the antenna switch pin
      */
-    virtual uint8_t DetectBoardType( void );    
-    
+    virtual uint8_t DetectBoardType( void );
+
     /*!
      * @brief Checks if the given RF frequency is supported by the hardware
      *
@@ -145,15 +152,15 @@
      * @retval isSupported [true: supported, false: unsupported]
      */
     virtual bool CheckRfFrequency( uint32_t frequency );
-    
-        /*!
+
+    /*!
      * @brief Writes the radio register at the specified address
      *
      * @param [IN]: addr Register address
      * @param [IN]: data New register value
      */
     virtual void Write ( uint8_t addr, uint8_t data ) ;
-    
+
     /*!
      * @brief Reads the radio register at the specified address
      *
@@ -161,7 +168,7 @@
      * @retval data Register value
      */
     virtual uint8_t Read ( uint8_t addr ) ;
-    
+
     /*!
      * @brief Writes multiple radio registers starting at address
      *
@@ -170,7 +177,7 @@
      * @param [IN] size   Number of registers to be written
      */
     virtual void Write( uint8_t addr, uint8_t *buffer, uint8_t size ) ;
-    
+
     /*!
      * @brief Reads multiple radio registers starting at address
      *
@@ -179,7 +186,7 @@
      * @param [IN] size Number of registers to be read
      */
     virtual void Read ( uint8_t addr, uint8_t *buffer, uint8_t size ) ;
-    
+
     /*!
      * @brief Writes the buffer contents to the SX1276 FIFO
      *
@@ -195,7 +202,7 @@
      * @param [IN] size Number of bytes to be read from the FIFO
      */
     virtual void ReadFifo( uint8_t *buffer, uint8_t size ) ;
-    
+
     /*!
      * @brief Reset the SX1276
      */