I messed up the merge, so pushing it over to another repo so I don't lose it. Will tidy up and remove later
Dependencies: BufferedSerial FatFileSystemCpp mbed
settings.txt
- Committer:
- JamieB
- Date:
- 2021-08-12
- Revision:
- 42:9653486372a6
- Parent:
- 39:3cd9e498b5c6
- Child:
- 47:8d577dfb7eb1
File content as of revision 42:9653486372a6:
[Serial Output Format] # Sets the serial output format. # 0 = VIPS (Default) # 1 = FreeD -------------------------------- Output_Format=0 -------------------------------- [Fiz Format] # Sets the FIZ reader to use # 0 - Preston (default) # 1 - Fuji passive listen mode (skycam) # 2 - Fuji active mode # 3 - Canon -------------------------------- FIZ_Format=3 -------------------------------- [Ethernet Port] # Sets the UDP port for FreeD network output. # Data is sent as a UDP broadcast on the select port number. # A port number of 0 disables UDP output. -------------------------------- FreeD_Port=12345 VIPS_UDP_Port=7000 -------------------------------- [Network Settings] # Set the Static IPv4 address to use for the ethernet interface. # NOTE: All 3 values must be set for a static address to be used otherwise DHCP will be used. # Comment out the line using any additional characters at the beginning to ignore -------------------------------- //IP_addr=aaa.bbb.ccc.ddd //Subnet=aaa.bbb.ccc.ddd //Gateway=aaa.bbb.ccc.ddd -------------------------------- [Filter_Settings] #Low pass filter settings for channels that have it enabled. #Filter is of order n with a cut off at m Hz assuming input data rate is at r Hz #Filter order must be set to enable filters. #Frequency default is 10Hz #Rate default is 100Hz //FilterOrder=1 //FilterFreq=7 //FilterRate=100 //FilterXY=0 //FilterZ=0 //FilterRoll=0 //FilterPitch=1 //FilterYaw=0 # Enable channels to low pass filter. All filters use the settings given above. # A value of 1 enables the filter. A value of 0 or skipping the line disables the filter. # NOTE-The filter will add latency so a filtered channel will be delayed relative to an unfiltered one. [NOTES] - All settings are case sensitive. - Do NOT include spaces in the options lines. - All options default to a value of 0 if omitted from the file.