File content as of revision 7:315942f167d7:

/* mbed Example Program
 * Copyright (c) 2006-2014 ARM Limited
 *
 * Licensed under the Apache License, Version 2.0 (the "License");
 * you may not use this file except in compliance with the License.
 * You may obtain a copy of the License at
 *
 *     http://www.apache.org/licenses/LICENSE-2.0
 *
 * Unless required by applicable law or agreed to in writing, software
 * distributed under the License is distributed on an "AS IS" BASIS,
 * WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
 * See the License for the specific language governing permissions and
 * limitations under the License.
 */
#include "mbed.h"

DigitalIn  mypin(BUTTON1); // change this to the button on your board
DigitalOut myled(LED1);

int main()
{
    // check mypin object is initialized and connected to a pin
    int check = mypin.is_connected();  
    if(check) {
        printf("mypin is connected and initialized! \n\r");
    }
    
    // Set resistance on line
    mypin.mode(PullNone); // valid modes are PullUp, PullDown, PullNone, OpenDrain
    
    // press the button and see the console / led change
    while(1) {
        printf("mypin has value : %d \n\r", mypin.read());
        myled = mypin; // toggle led based on value of button
        wait(0.25);
    }
}