Dependencies: Motordriver mbed
Showing the setup and calibration: Part1
In this part the Wifi setups and attains an IP address so we can control it through a webpage on our phone/PC.
After it obtains an IP address it calibrates the IMU so we can have accurate compass headings for precise turns.
The parts that we use are as follows:
- Mbed
- 2 DC motors
- H-Bridge (to drive the DC motors)
- Speaker
- Class D Amp (to drive the Speaker)
- IMU (use the magnometer for compass headings)
- Wifi card (ESP8266)
Showing webpage functionality and Robot Functionality: In this part we demonstrate the functionality of the robot and the webpage to control it.
Final Code
[Repository '/teams/Prana-Koirala/code/Wifi_controlled_Robot_ECE4180/docs/tip/main_8cpp_source.html' not found]