![](/media/cache/group/NXP_logo_RGB_web.png.50x50_q85.jpg)
The MCR20A Wireless UART application functions as an wireless UART bridge between two (one-to-one) or several (one to many) boards. The application can be used with both a TERM, or with software that is capable of opening a serial port and writing to or reading from it. The characters sent or received are not necessarily ASCII printable characters.
Dependencies: fsl_phy_mcr20a fsl_smac mbed-rtos mbed
Fork of mcr20_wireless_uart by
By default, the application uses broadcast addresses for OTA communication. This way, the application can be directly downloaded and run without any user intervention. The following use case assumes no changes have been done to the project.
- Two (or more) MCR20A platforms (plugged into the FRDM-K64F Freescale Freedom Development platform) have to be connected to the PC using the mini/micro-USB cables.
- The code must be downloaded on the platforms via CMSIS-DAP (or other means).
- After that, two or more TERM applications must be opened, and the serial ports must be configured with the same baud rate as the one in the project (default baud rate is 115200). Other necessary serial configurations are 8 bit, no parity, and 1 stop bit.
- To start the setup, each platform must be reset, and one of the (user) push buttons found on the MCR20A platform must be pressed. The user can press any of the non-reset buttons on the FRDM-K64F Freescale Freedom Development platform as well. *This initiates the state machine of the application so user can start.
Documentation
SMAC Demo Applications User Guide
mbed.bld@28:2555c5ae3ccd, 2015-08-18 (annotated)
- Committer:
- andreikovacs
- Date:
- Tue Aug 18 13:04:46 2015 +0000
- Revision:
- 28:2555c5ae3ccd
- Parent:
- 18:b02fc0e53df8
Added fsl_phy_mcr20a and fsl_smac libraries
Who changed what in which revision?
User | Revision | Line number | New contents of line |
---|---|---|---|
cotigac | 18:b02fc0e53df8 | 1 | http://mbed.org/users/mbed_official/code/mbed/builds/487b796308b0 |