Maxim Integrated


Maxim's microcontrollers provide low-power, efficient, and secure solutions for challenging embedded applications.

MAX32625PICO Firmware Updates

MAX32625PICO Firmware Updates

/media/uploads/switches/max32625pico_maxdap.png Just like most DAPLink interfaces, the MAX32625PICO board comes pre-installed with a bootloader that enables driverless drag-n-drop updates. This bootloader can be used to update or restore the DAPLink firmware on the MAX32625PICO board or it can also be used to load your own custom application on the board. This allows you to use the MAX32625PICO board as a tiny, embeddable development platform. To activate the bootloader, simply hold the lone button down while applying power to the board. When the bootloader detects the button press at power on, it will connect to the PC as a drive named "MAINTENANCE". Simply Drag-n-Drop the desired image onto the MAINTENANCE drive to load new firmware into the board.

Here are the links to several DAPLink images for a variety of different target platforms:

FileDrag-n-Drop Target BoardInterface Version
max32625pico_daplink.bin
Default factory image.
MAX32630FTHR0242
max32625pico_max32620fthr_if_crc.binMAX32620FTHR0254
max32625pico_max32625pico.binMAX32625PICO0243
max32625pico_max32630fthr_if_crc.binMAX32630FTHR0254
max32625pico_max32630hsp.binMAX32630HSP30243
max32625pico_max32660_vio_in.binMAX32660
VIO is input.
0243
max32625pico_max32660_power_out.binMAX32660
Applies 3.3V to VIO!
0243

Information

All images support CDC virtual UART and HID CMSIS-DAP debugging/programming with any target. Only MSD drag-n-drop programming is specific to the targets listed above.

Warning

Be careful when using the MAX32660 image with 3.3V power output. This image will apply 3.3V to the VIO pin of the MAXDAP connector which is incompatible with many targets. This allows using the MAX32625PICO board to power the MAX32660 Evaluation Kit, but it may permanently damage other target boards that connect VIO to 1.8V.


All wikipages