File content as of revision 1:5431d59ee324:

#include "mbed.h"
#include "m3pi.h"

m3pi m3pi;

// Minimum and maximum motor speeds
#define MAX 1.0
#define MIN 0

// PID terms
#define P_TERM 1
#define I_TERM 0
#define D_TERM 20

int main() {
    float a=m3pi.battery();
    float b=m3pi.pot_voltage();
    m3pi.locate(0,0);
    
       
    m3pi.cls();
    m3pi.printf("%f.3 ",a);
    m3pi.locate(0,1);
    m3pi.printf("%f.3 ",b);
    
    
    // dette er en mega god kommentar 13:44

    wait(2.0);

    m3pi.sensor_auto_calibrate();

    float right;
    float left;
    float current_pos_of_line = 0.0;
    float previous_pos_of_line = 0.0;
    float derivative,proportional,integral = 0;
    float power;
    float speed = MAX;
    
    while (1) {

        // Get the position of the line.
        current_pos_of_line = m3pi.line_position();        
        proportional = current_pos_of_line;
        
        // Compute the derivative
        derivative = current_pos_of_line - previous_pos_of_line;
        
        // Compute the integral
        integral += proportional;
        
        // Remember the last position.
        previous_pos_of_line = current_pos_of_line;
        
        // Compute the power
        power = (proportional * (P_TERM) ) + (integral*(I_TERM)) + (derivative*(D_TERM)) ;
        
        // Compute new speeds   
        right = speed+power;
        left  = speed-power;
        
        // limit checks
        if (right < MIN)
            right = MIN;
        else if (right > MAX)
            right = MAX;
            
        if (left < MIN)
            left = MIN;
        else if (left > MAX)
            left = MAX;
            
       // set speed 
        m3pi.left_motor(left);
        m3pi.right_motor(right);

    }
}