File content as of revision 2:9bab1d673af9:

#include "mbed.h"

#define VREF                   3300.0f    /* Device power supply in mV */

// Parameters for temperature sensor only
#define AMBIENT_TEMP             25.0f    /* Ambient Temperature in °C */
#define VSENS_AT_AMBIENT_TEMP   760.0f    /* VSENSE value in mV at ambient temperature */
#define AVG_SLOPE                25.0f    /* Average slope in mV/°C multiplied by 10 */

//AnalogIn vbat(ADC_VBAT); // To measure VBat
AnalogIn tempsensor(ADC_TEMP); // To measure Temperature sensor

DigitalOut led(LED1);

int main()
{
    float meas_f;
    float JTemp_f;

    printf("\nSTM32 Internal Channels example\n");

    while(1) {

        /*
        Note 1: As VBAT voltage could be higher than VDDA, to ensure the correct operation of the ADC, the
        VBAT pin is internally connected to a bridge divider by 4.
        Note 2: On some devices the VBAT and temperature sensor are connected to the same ADC internal channel
        Only one conversion, either temperature sensor or VBAT, must be selected at a time.
        When both conversion are enabled simultaneously, only the VBAT conversion is
        performed.
        */
        //printf("\nVBat = %.1f mV\n", vbat.read() * VREF * 4);

        meas_f = tempsensor.read();

        /* Compute the Junction Temperature value
        JTemp = ((Vsens - V25)/Avg_Slope) + 25°C
        The internal temperature sensor supports a temperature range of –40 to 125°C with an accuracy of +/-1.5°C. */

        JTemp_f = (((meas_f * VREF) - VSENS_AT_AMBIENT_TEMP) * 10.0f / AVG_SLOPE) + AMBIENT_TEMP;

        printf("Internal Temperature = %.1f degree C\n", JTemp_f);

        led = !led;
        wait(1.0);
    }
}