main.cpp

00001 // A simple IO demo using the MCP23S17 library
00002 //
00003 // MCP23S17 Library Copyright (c) 2010 Romilly Cocking
00004 // Released under the MIT License: http://mbed.org/license/mit
00005 //
00006 // See http://mbed.org/users/romilly/notebook/mcp23s17-addressable-16-bit-io-expander-with-spi/
00007 //
00008 //
00009 // MCP23S17 datasheet http://ww1.microchip.com/downloads/en/DeviceDoc/21952b.pdf
00010 // uses MCP23S17 library version 0.4
00011 
00012 #include "mbed.h"
00013 #include "MCP23S17.h"
00014 // Create SPI bus
00015 SPI spi(p5, p6, p7);
00016 // 
00017 // Wiring Connections:
00018 // mbed p5,p6,p7 are tied to MCP23S17 SI, SO, SCK pins
00019 // mbed p20 to MCP23S17 CS
00020 // MCP23S17 reset pin pulled high
00021 // MCP23S17 GPA0 connected to GPB0 for loopback test
00022 // A0, A1, A2 of the MCP23S17  are tied to ground on the breadboard, so the 8-bit address for writes is 0x40
00023 // This is referred to as the opcode in the device datasheet
00024 char Opcode = 0x40;
00025 
00026 // Next create a MCP23S17
00027 // mbed p20 is connected to ~chipSelect on the MCP23S17
00028 MCP23S17 chip = MCP23S17(spi, p20, Opcode);
00029 
00030 // Optional software reset - mbed p14 to MCP23S17 reset pin
00031 // DigitalOut reset(p14);
00032 
00033  // mbed LED1 is used for test status display
00034 int B0;
00035 int main() {
00036 //  The MCP23S17 reset pin can just be pulled high, since it has a power on reset circuit.
00037 //  The reset pin can be used for a software forced reset by pulling it low with an mbed GPIO pin.
00038 //  But just leave it pulled high for this simple demo code.
00039 //  After a power on reset, both IO ports default to input mode
00040 //
00041 //  Here is the optional code for a software reset
00042 //  reset = 0;
00043 //  wait_us(1);
00044 //  reset = 1;
00045 //
00046 //  Set all 8 Port A bits to output direction
00047     chip.direction(PORT_A, 0x00);
00048 //  Set all 8 Port B bits to input direction
00049     chip.direction(PORT_B, 0xFF);
00050     chip.configurePullUps(PORT_B,true);
00051 //  Start Loopback test sending out and reading back values
00052 //  loopback test uses A0 and B0 pins - so use a wire to jumper those two pins on MCP23S17 together
00053     while (1) {
00054         B0 = chip.read(PORT_B)& 0x01;
00055         if(B0 == 0){
00056         chip.write(PORT_A,1);
00057         } else if  (B0 == 1) {
00058           chip.write(PORT_A,0);
00059         }   
00060     }
00061 }