Digi International Inc. / Mbed 2 deprecated XBeeZB_AT_Commands

ZigBee AT Commands example for mbed XBeeLib By Digi

Dependencies:   XBeeLib mbed

This example shows how to read and change configuration parameters of either the local XBee module or a remote XBee module.

See Configuring local and remote modules chapter for more information.

Common Setup

Make sure you have a valid Example Common Setup

Example Setup

Application

You have to configure the remote device 64-bit address by customizing the REMOTE_NODE_ADDR64_MSB and REMOTE_NODE_ADDR64_LSB defines with the remote XBee module 64-bit address.

Running the example

Build and deploy the example to the mbed module.
Reset the mbed module so the example starts. You should see the example debug information through the debug interface configured in the 'Local Setup' chapter.
Once joined to the coordinator, the application will do following operations:

OperationXBee moduleparameterVerification
ReadlocalSLThe result is asserted against the known local module SL value. So just check the assertion passed
SetlocalNIClick 'discover remote devices' on the X-CTU connected to the remote. Should discover the local XBee module with the new NI (ni_example_local)
ReadremoteSLThe result is asserted against the known remote module SL value. So just check the assertion passed
SetremoteNIRefresh the 'NI' parameter in the X-CTU connected to the remote and check it has changed to the new NI (ni_example_remote)

config.h

Committer:
hbujanda
Date:
2015-04-29
Revision:
0:fd8c52820c01
Child:
1:f5686759c861

File content as of revision 0:fd8c52820c01:


#if !defined(__CONFIG_H_)
#define __CONFIG_H_

//#define PATFORM_ARCHPRO

/** Library configuration options */
#define ENABLE_LOGGING
#define ENABLE_ASSERTIONS
#define FRAME_BUFFER_SIZE   4
#define MAX_FRAME_PAYLOAD_LEN  128
#define ENABLE_PM_SUPPORT

#define SYNC_OPS_TIMEOUT_MS       2000
#define REM_SYNC_OPS_TIMEOUT_MS   3000

#if defined(PATFORM_ARCHPRO)
#define RADIO_TX            P4_28
#define RADIO_RX            P4_29
#define RADIO_RESET         NC
//#define RADIO_RESET         NC
#define RADIO_SLEEP_REQ     NC
#define RADIO_ON_SLEEP      NC
#define DEBUG_TX            P0_2
#define DEBUG_RX            P0_3
#elif defined(TARGET_LPC1768)
#define RADIO_TX            p9
#define RADIO_RX            p10
#define RADIO_RESET         p30
#define RADIO_SLEEP_REQ     NC
#define RADIO_ON_SLEEP      NC
#define DEBUG_TX            P0_2
#define DEBUG_RX            P0_3
#elif defined(TARGET_FRDM_KL25)
#define RADIO_TX            PTD3
#define RADIO_RX            PTD2
#define RADIO_RESET         NC
#define RADIO_SLEEP_REQ     NC
#define RADIO_ON_SLEEP      NC
#define DEBUG_TX            USBTX
#define DEBUG_RX            USBRX
#elif (defined TARGET_LPC11U24)
#define RADIO_TX            p9
#define RADIO_RX            p10
#define RADIO_RESET         p30
#define RADIO_SLEEP_REQ     NC
#define RADIO_ON_SLEEP      NC
#define DEBUG_TX            USBTX
#define DEBUG_RX            USBRX
#else
#error "Define a platform"
#endif

#endif /* __CONFIG_H_ */