Digi International Inc.
DigiMesh Send Data example for mbed XBeeLib By Digi
Fork of
XBeeZB_Send_Data
by 
Digi International Inc.
Description
This example shows how to send data to a remote XBeeDM module.
The application creates a message for a remote XBee module.
This library encodes and sends it to the local XBee module through the serial port. Then the local XBee module sends the packet to the remote XBee module through the air.
The example shows how to send both unicast and broadcast messages.
See Sending data to another module chapter for more information.
Common Setup
Make sure you have a valid Example Common Setup
Example Setup
Application
Broadcast messages doesn't require any configuration, but for unicast messages to a specific node you have to configure the remote device 64-bit address by customizing the REMOTE_NODE_ADDR64_MSB and REMOTE_NODE_ADDR64_LSB defines with the remote XBee module 64-bit address.
Running the example
Build and deploy the example to the mbed module.
Reset the mbed module so the example starts. You should see the example debug information through the debug interface configured in the 'Local Setup' chapter.
The application will first send a broadcast message and finally a couple of unicast messages to the configured remote XBee module.
Verify that the remote XBee module is receiving the frames by accessing the "Console" tab of the X-CTU. You should see there the broadcast and unicast messages.