Repostiory containing DAPLink source code with Reset Pin workaround for HANI_IOT board.

Upstream: https://github.com/ARMmbed/DAPLink

source/family/onsemi/ncs36510/target.c

Committer:
Pawel Zarembski
Date:
2020-04-07
Revision:
0:01f31e923fe2

File content as of revision 0:01f31e923fe2:

/* CMSIS-DAP Interface Firmware
 * Copyright (c) 2009-2013 ARM Limited
 *
 * Licensed under the Apache License, Version 2.0 (the "License");
 * you may not use this file except in compliance with the License.
 * You may obtain a copy of the License at
 *
 *     http://www.apache.org/licenses/LICENSE-2.0
 *
 * Unless required by applicable law or agreed to in writing, software
 * distributed under the License is distributed on an "AS IS" BASIS,
 * WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
 * See the License for the specific language governing permissions and
 * limitations under the License.
 */

#include "target_config.h"

// The file flash_blob.c must only be included in target.c
#include "flash_blob.c"

// target information
target_cfg_t target_device = {
    .sectors_info                   = sectors_info,
    .sector_info_length             = (sizeof(sectors_info))/(sizeof(sector_info_t)),
    .flash_regions[0].start         = 0x00002000,
    .flash_regions[0].end           = 0x00151FFF,
    .flash_regions[0].flags         = kRegionIsDefault,
    .flash_regions[0].flash_algo    = (program_target_t *) &flash,    
    .ram_regions[0].start           = 0x3FFF4000,
    .ram_regions[0].end             = 0x3FFFFFFF,
};