File content as of revision 0:01f31e923fe2:

/**
 * @file    target_reset.c
 * @brief   Target reset for the MAX32625
 *
 * DAPLink Interface Firmware
 * Copyright (c) 2009-2016, ARM Limited, All Rights Reserved
 * SPDX-License-Identifier: Apache-2.0
 *
 * Licensed under the Apache License, Version 2.0 (the "License"); you may
 * not use this file except in compliance with the License.
 * You may obtain a copy of the License at
 *
 * http://www.apache.org/licenses/LICENSE-2.0
 *
 * Unless required by applicable law or agreed to in writing, software
 * distributed under the License is distributed on an "AS IS" BASIS, WITHOUT
 * WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
 * See the License for the specific language governing permissions and
 * limitations under the License.
 */

#include "swd_host.h"

void target_before_init_debug(void)
{
    // any target specific sequences needed before attaching
    // to the DAP across JTAG or SWD
    return;
}

uint8_t target_unlock_sequence(void)
{
    // if the device can secure the flash and there is a way to
    //  erase all it should be implemented here.
    return 1;
}

uint8_t target_set_state(target_state_t state)
{
    // invoke reset by sw (VECT_REQ or SYS_REQ) or hw (hardware IO toggle)
    // return swd_set_target_state_sw(state);
    //or
    return swd_set_target_state_hw(state);
}

uint8_t security_bits_set(uint32_t addr, uint8_t *data, uint32_t size)
{
    // if there are security bits in the programmable flash region
    //  a check should be performed. This method is used when programming
    //  by drag-n-drop and should refuse to program an image requesting
    //  to set the device security. This can be performed with the debug channel
    //  if needed.
    return 0;
}