Diff: source/hic_hal/freescale/kl26z/IO_Config.h

Revision:

0:01f31e923fe2

--- /dev/null	Thu Jan 01 00:00:00 1970 +0000
+++ b/source/hic_hal/freescale/kl26z/IO_Config.h	Tue Apr 07 12:55:42 2020 +0200
@@ -0,0 +1,127 @@
+/**
+ * @file    IO_Config.h
+ * @brief   
+ *
+ * DAPLink Interface Firmware
+ * Copyright (c) 2009-2016, ARM Limited, All Rights Reserved
+ * SPDX-License-Identifier: Apache-2.0
+ *
+ * Licensed under the Apache License, Version 2.0 (the "License"); you may
+ * not use this file except in compliance with the License.
+ * You may obtain a copy of the License at
+ *
+ * http://www.apache.org/licenses/LICENSE-2.0
+ *
+ * Unless required by applicable law or agreed to in writing, software
+ * distributed under the License is distributed on an "AS IS" BASIS, WITHOUT
+ * WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
+ * See the License for the specific language governing permissions and
+ * limitations under the License.
+ */
+
+// Override all defines if IO_CONFIG_OVERRIDE is defined
+#ifdef IO_CONFIG_OVERRIDE
+#include "IO_Config_Override.h"
+#ifndef __IO_CONFIG_H__
+#define __IO_CONFIG_H__
+#endif
+#endif
+
+#ifndef __IO_CONFIG_H__
+#define __IO_CONFIG_H__
+
+#include "MKL26Z4.h"
+#include "compiler.h"
+#include "daplink.h"
+
+// This GPIO configuration is only valid for the KL26 HIC
+COMPILER_ASSERT(DAPLINK_HIC_ID == DAPLINK_HIC_ID_KL26);
+
+
+// Debug Port I/O Pins
+
+// SWCLK Pin                    PTC5(C5)
+#define PIN_SWCLK_PORT          PORTC
+#define PIN_SWCLK_GPIO          PTC
+#define PIN_SWCLK_BIT           (5)
+#define PIN_SWCLK               (1<<PIN_SWCLK_BIT)
+
+// SWDIO Pin                    PTC6(C6)
+#define PIN_SWDIO_PORT          PORTC
+#define PIN_SWDIO_GPIO          PTC
+#define PIN_SWDIO_BIT           (6)
+#define PIN_SWDIO               (1<<PIN_SWDIO_BIT)
+
+// nRESET Pin                   PTC8(C8)
+#define PIN_nRESET_PORT         PORTC
+#define PIN_nRESET_GPIO         PTC
+#define PIN_nRESET_BIT          (8)
+#define PIN_nRESET              (1<<PIN_nRESET_BIT)
+
+// PWR_REG_EN PTD2 - Not connected
+#define PIN_POWER_EN_PORT       PORTD
+#define PIN_POWER_EN_GPIO       PTD
+#define PIN_POWER_EN_BIT        (2)
+#define PIN_POWER_EN            (1<<PIN_POWER_EN_BIT)
+
+// VTRG_FAULT_B PTD3 - Not connected
+#define PIN_VTRG_FAULT_B_PORT   PORTD
+#define PIN_VTRG_FAULT_B_GPIO   PTD
+#define PIN_VTRG_FAULT_B_BIT    (7)
+#define PIN_VTRG_FAULT_B_EN     (1<<PIN_VTRG_FAULT_B_BIT)
+
+// Debug Unit LEDs
+
+// HID_LED PTD4
+#define PIN_HID_LED_PORT        PORTD
+#define PIN_HID_LED_GPIO        PTD
+#define PIN_HID_LED_BIT         (4)
+#define PIN_HID_LED             (1<<PIN_HID_LED_BIT)
+
+// MSC_LED PTD5
+#define PIN_MSC_LED_PORT        PORTD
+#define PIN_MSC_LED_GPIO        PTD
+#define PIN_MSC_LED_BIT         (4)
+#define PIN_MSC_LED             (1<<PIN_MSC_LED_BIT)
+
+// CDC_LED PTD6
+#define PIN_CDC_LED_PORT        PORTD
+#define PIN_CDC_LED_GPIO        PTD
+#define PIN_CDC_LED_BIT         (4)
+#define PIN_CDC_LED             (1<<PIN_CDC_LED_BIT)
+
+// SW RESET BUTTON PTB1
+#define PIN_SW_RESET_PORT       PORTB
+#define PIN_SW_RESET_GPIO       PTB
+#define PIN_SW_RESET_BIT        (1)
+#define PIN_SW_RESET            (1<<PIN_SW_RESET_BIT)
+
+// BOARD TYPE
+#define PIN_BOARD_TYPE_PORT     PORTB
+#define PIN_BOARD_TYPE_GPIO     PTB
+#define PIN_BOARD_TYPE_BIT      (0)
+#define PIN_BOARD_TYPE          (1<<PIN_BOARD_TYPE_BIT)
+
+// Connected LED                Not available
+
+// Target Running LED           Not available
+
+// UART
+#define UART_PORT               PORTC
+#define UART_NUM                (1)
+// RX PTC3
+#define PIN_UART_RX_GPIO        PTC
+#define PIN_UART_RX_BIT         (3)
+#define PIN_UART_RX             (1<<PIN_UART_RX_BIT)
+#define PIN_UART_RX_MUX_ALT     (3)
+// TX PTC4
+#define PIN_UART_TX_GPIO        PTC
+#define PIN_UART_TX_BIT         (4)
+#define PIN_UART_TX             (1<<PIN_UART_TX_BIT)
+#define PIN_UART_TX_MUX_ALT     (3)
+
+#define UART                    UART1
+#define UART_RX_TX_IRQn         UART1_IRQn
+#define UART_RX_TX_IRQHandler   UART1_IRQHandler
+
+#endif