Diff: source/family/realtek/rtl8195am/target.c

Revision:

0:01f31e923fe2

--- /dev/null	Thu Jan 01 00:00:00 1970 +0000
+++ b/source/family/realtek/rtl8195am/target.c	Tue Apr 07 12:55:42 2020 +0200
@@ -0,0 +1,52 @@
+/**
+ * @file    target.c
+ * @brief   Target information for Realtek RTL8195AM
+ *
+ * DAPLink Interface Firmware
+ * Copyright (c) 2016-2019, Realtek Semiconductor Corp., All Rights Reserved
+ * SPDX-License-Identifier: Apache-2.0
+ *
+ * Licensed under the Apache License, Version 2.0 (the "License"); you may
+ * not use this file except in compliance with the License.
+ * You may obtain a copy of the License at
+ *
+ * http://www.apache.org/licenses/LICENSE-2.0
+ *
+ * Unless required by applicable law or agreed to in writing, software
+ * distributed under the License is distributed on an "AS IS" BASIS, WITHOUT
+ * WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
+ * See the License for the specific language governing permissions and
+ * limitations under the License.
+ */
+
+#include "target_config.h"
+
+// The file flash_blob.c must only be included in target.c
+#include "flash_blob.c"
+
+// target information
+target_cfg_t target_device = {
+    .sectors_info                   = sectors_info,
+    .sector_info_length             = (sizeof(sectors_info))/(sizeof(sector_info_t)),
+    .flash_regions[0].start         = 0x00000000,
+    .flash_regions[0].end           = 0x00000000 + MB(2),
+    .flash_regions[0].flags         = kRegionIsDefault,
+    .flash_regions[0].flash_algo    = (program_target_t *) &flash,    
+    .ram_regions[0].start           = 0x10007000,
+    .ram_regions[0].end             = 0x10070000,
+};
+
+// RTL8195AM's main cpu can only talk 38400 with DAP UART
+#include "uart.h"
+static UART_Configuration UART_Config;
+
+int32_t USBD_CDC_ACM_SetLineCoding(void)
+{
+    UART_Config.Baudrate    = 38400;
+    UART_Config.DataBits    = UART_DATA_BITS_8;
+    UART_Config.Parity      = UART_PARITY_NONE;
+    UART_Config.StopBits    = UART_STOP_BITS_1;
+    UART_Config.FlowControl = UART_FLOW_CONTROL_NONE;
+
+    return uart_set_configuration(&UART_Config);
+}