Diff: drivers/network/COMPONENT_WIFI_ESP32/ESP32Stack.h

Revision:

0:43ff9e3bc244

--- /dev/null	Thu Jan 01 00:00:00 1970 +0000
+++ b/drivers/network/COMPONENT_WIFI_ESP32/ESP32Stack.h	Tue Mar 12 13:48:39 2019 +0800
@@ -0,0 +1,177 @@
+/* ESP32 implementation of NetworkInterfaceAPI
+ * Copyright (c) 2015 ARM Limited
+ * Copyright (c) 2017 Renesas Electronics Corporation
+ *
+ * Licensed under the Apache License, Version 2.0 (the "License");
+ * you may not use this file except in compliance with the License.
+ * You may obtain a copy of the License at
+ *
+ *     http://www.apache.org/licenses/LICENSE-2.0
+ *
+ * Unless required by applicable law or agreed to in writing, software
+ * distributed under the License is distributed on an "AS IS" BASIS,
+ * WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
+ * See the License for the specific language governing permissions and
+ * limitations under the License.
+ */
+
+#ifndef ESP32_STACK_H
+#define ESP32_STACK_H
+
+#include "mbed.h"
+#include "ESP32.h"
+
+/** ESP32Stack class
+ *  Implementation of the NetworkStack for the ESP32
+ */
+class ESP32Stack : public NetworkStack
+{
+protected:
+    /** ESP32Stack lifetime
+     * @param en        EN pin
+     * @param io0       IO0 pin
+     * @param tx        TX pin
+     * @param rx        RX pin
+     * @param debug     Enable debugging
+     * @param rts       RTS pin
+     * @param cts       CTS pin
+     * @param baudrate  The baudrate of the serial port.
+     */
+    ESP32Stack(PinName en, PinName io0, PinName tx, PinName rx, bool debug,
+               PinName rts, PinName cts, int baudrate);
+
+protected:
+    /** Open a socket
+     *  @param handle       Handle in which to store new socket
+     *  @param proto        Type of socket to open, NSAPI_TCP or NSAPI_UDP
+     *  @return             0 on success, negative on failure
+     */
+    virtual int socket_open(void **handle, nsapi_protocol_t proto);
+
+    /** Close the socket
+     *  @param handle       Socket handle
+     *  @return             0 on success, negative on failure
+     *  @note On failure, any memory associated with the socket must still
+     *        be cleaned up
+     */
+    virtual int socket_close(void *handle);
+
+    /** Bind a server socket to a specific port
+     *  @param handle       Socket handle
+     *  @param address      Local address to listen for incoming connections on
+     *  @return             0 on success, negative on failure.
+     */
+    virtual int socket_bind(void *handle, const SocketAddress &address);
+
+    /** Start listening for incoming connections
+     *  @param handle       Socket handle
+     *  @param backlog      Number of pending connections that can be queued up at any
+     *                      one time [Default: 1]
+     *  @return             0 on success, negative on failure
+     */
+    virtual int socket_listen(void *handle, int backlog);
+
+    /** Connects this TCP socket to the server
+     *  @param handle       Socket handle
+     *  @param address      SocketAddress to connect to
+     *  @return             0 on success, negative on failure
+     */
+    virtual int socket_connect(void *handle, const SocketAddress &address);
+
+    /** Accept a new connection.
+     *  @param handle       Handle in which to store new socket
+     *  @param server       Socket handle to server to accept from
+     *  @return             0 on success, negative on failure
+     *  @note This call is not-blocking, if this call would block, must
+     *        immediately return NSAPI_ERROR_WOULD_WAIT
+     */
+    virtual int socket_accept(void *handle, void **socket, SocketAddress *address);
+
+    /** Send data to the remote host
+     *  @param handle       Socket handle
+     *  @param data         The buffer to send to the host
+     *  @param size         The length of the buffer to send
+     *  @return             Number of written bytes on success, negative on failure
+     *  @note This call is not-blocking, if this call would block, must
+     *        immediately return NSAPI_ERROR_WOULD_WAIT
+     */
+    virtual int socket_send(void *handle, const void *data, unsigned size);
+
+    /** Receive data from the remote host
+     *  @param handle       Socket handle
+     *  @param data         The buffer in which to store the data received from the host
+     *  @param size         The maximum length of the buffer
+     *  @return             Number of received bytes on success, negative on failure
+     *  @note This call is not-blocking, if this call would block, must
+     *        immediately return NSAPI_ERROR_WOULD_WAIT
+     */
+    virtual int socket_recv(void *handle, void *data, unsigned size);
+
+    /** Send a packet to a remote endpoint
+     *  @param handle       Socket handle
+     *  @param address      The remote SocketAddress
+     *  @param data         The packet to be sent
+     *  @param size         The length of the packet to be sent
+     *  @return             The number of written bytes on success, negative on failure
+     *  @note This call is not-blocking, if this call would block, must
+     *        immediately return NSAPI_ERROR_WOULD_WAIT
+     */
+    virtual int socket_sendto(void *handle, const SocketAddress &address, const void *data, unsigned size);
+
+    /** Receive a packet from a remote endpoint
+     *  @param handle       Socket handle
+     *  @param address      Destination for the remote SocketAddress or null
+     *  @param buffer       The buffer for storing the incoming packet data
+     *                      If a packet is too long to fit in the supplied buffer,
+     *                      excess bytes are discarded
+     *  @param size         The length of the buffer
+     *  @return             The number of received bytes on success, negative on failure
+     *  @note This call is not-blocking, if this call would block, must
+     *        immediately return NSAPI_ERROR_WOULD_WAIT
+     */
+    virtual int socket_recvfrom(void *handle, SocketAddress *address, void *buffer, unsigned size);
+
+    /** Register a callback on state change of the socket
+     *  @param handle       Socket handle
+     *  @param callback     Function to call on state change
+     *  @param data         Argument to pass to callback
+     *  @note Callback may be called in an interrupt context.
+     */
+    virtual void socket_attach(void *handle, void (*callback)(void *), void *data);
+
+    /** Set stack-specific socket options
+     *  The setsockopt allow an application to pass stack-specific hints
+     *  to the underlying stack. For unsupported options,
+     *  NSAPI_ERROR_UNSUPPORTED is returned and the socket is unmodified.
+     *
+     *  @param handle   Socket handle
+     *  @param level    Stack-specific protocol level
+     *  @param optname  Stack-specific option identifier
+     *  @param optval   Option value
+     *  @param optlen   Length of the option value
+     *  @return         0 on success, negative error code on failure
+     */
+    virtual nsapi_error_t setsockopt(nsapi_socket_t handle, int level,
+            int optname, const void *optval, unsigned optlen);
+
+    /** Get stack-specific socket options
+     *  The getstackopt allow an application to retrieve stack-specific hints
+     *  from the underlying stack. For unsupported options,
+     *  NSAPI_ERROR_UNSUPPORTED is returned and optval is unmodified.
+     *
+     *  @param handle   Socket handle
+     *  @param level    Stack-specific protocol level
+     *  @param optname  Stack-specific option identifier
+     *  @param optval   Destination for option value
+     *  @param optlen   Length of the option value
+     *  @return         0 on success, negative error code on failure
+     */
+    virtual nsapi_error_t getsockopt(nsapi_socket_t handle, int level,
+            int optname, void *optval, unsigned *optlen);
+
+protected:
+    ESP32 *_esp;
+    uint16_t _local_ports[ESP32::SOCKET_COUNT];
+};
+
+#endif