Example of using the ATT M2X back end. Connect over Wifi with the ESP8266 chip. This code sends accelerometer data to M2X. This code can be used for Any board, just change the RX/TX pins the wifi adapter is connected to.
Dependencies: ESP8266Interface FXOS8700Q M2XStreamClient jsonlite mbed
Fork of M2X_Nucleo411_Accel_ESP8266-wifi by
History
made default wifi pins match K64F
2015-12-11, by mbedAustin [Fri, 11 Dec 2015 00:25:01 +0000] rev 4
made default wifi pins match K64F
swapped out ethernet library with ESP8266 wifi library, pre-populated wifi with pin deffinitions for Nucleo 411 board
2015-12-11, by mbedAustin [Fri, 11 Dec 2015 00:19:45 +0000] rev 3
swapped out ethernet library with ESP8266 wifi library, pre-populated wifi with pin deffinitions for Nucleo 411 board
1 sec wait
2015-08-29, by jb8414 [Sat, 29 Aug 2015 17:14:53 +0000] rev 2
1 sec wait
Update with new M2XStreamClient
2015-08-29, by jb8414 [Sat, 29 Aug 2015 17:11:28 +0000] rev 1
Update with new M2XStreamClient
initial commit
2014-08-05, by jb8414 [Tue, 05 Aug 2014 14:46:55 +0000] rev 0
initial commit