Ales Zupanc

Important changes to forums and questions

All forums and questions are now archived. To start a new conversation or read the latest updates go to forums.mbed.com.

7 years, 10 months ago.

What do you think.

Hi everyone. I'm about to buy NUCLEO-F767ZI board, but first I want to know If problems that you were talking about above are still happening (not working printf and ethernet), or you got them work?

Regards, Ales Zupanc

Question relating to:

Last updated: 20 Apr 2021
STM32 Nucleo-144 development board with STM32F767ZIT6 MCU, supports Arduino, ST Zio and morpho connectivity

2 Answers

Luca Sevà
7 years, 8 months ago.

Hi Ales, personaly I have bought 2 on these boards and in the "testing period" I stumbled in the ethernet problem. Tried the tcp example with both my boards and the result was the same. Personaly I think that it was more a mbed compiler problem because now it's totally working. About the printf problem... if you mean the usb_serial interface over COM port I didn't encountered any problem. The only hard point is the read in the serial form a gui to the micro. I'm currently developing a srt of "testbench" with it and I'm having a bit of problem with that. Hope I've helped you.

Best regards.

Accepted Answer

Thank you for the answers! I've bought one and I must say that so far I didn't have any problems. Not even with ethernet.

posted by Ales Zupanc 04 Apr 2017
Chris DT
7 years, 10 months ago.

Hi Ales! I have the NUCLEO-F767ZI and have used it over the last few months with great success. No problem with printf and use the library F7_Ethernet for ethernet