Important changes to forums and questions
All forums and questions are now archived. To start a new conversation or read the latest updates go to forums.mbed.com.
9 years ago.
Is D8 actually PTC12 and not PTA0?
The schematic shows D8 as PTC12 and not PTA0. Would the mbed team please correct the pin map image on this page.
Please refer to this question where the issue is identified: http://developer.mbed.org/questions/7065/Pin-PTA0-D8/#answer7150
Question relating to:
1 Answer
9 years ago.
What revision of schematic are you referring to ? When k64f was added, the revision A was around, and in that schematic , D8 is PTA0. I haven't noticed this change in the newer revisions :(
I have just remembered, I reported this issue, as PTA0 is jtag related pin. I believe this was fixed in the newest revisions of board, so should be fixed. Please write me your revision of schematic you were referring to. I'll recheck, create an issue on github and fix it.
posted by 13 Apr 2015Thank you Martin. I used rev E1
I noticed a new rev E3 from: http://www.freescale.com/webapp/sps/site/prod_summary.jsp?code=FRDM-K64F&fpsp=1&tab=Design_Tools_Tab
Page 5 of the schematic shows PTC12 connected to J2 pin 2 of the Arduino Compatible Headers, which is D8.
posted by 13 Apr 2015
I was looking at Schematic rev E1
posted by -deleted- 13 Apr 2015I looked at rev e3, there was no mention of the change!
posted by HM Yoong 14 Apr 2015