9 years, 4 months ago.

Stuck at btle_init>>

I have exactly same problem as https://developer.mbed.org/questions/5694/stuck-on-btle_init/?c=19206. I know that post is 7 months old, but it seems I am stuck with the same problem. Connecting Pin11 and Pin31 on CN10 (double checked its not CN7) as shown didn't change anything.

I am using NucleoF411RE board with BlueNRG shield X-NUCLEO-IDB04A1.

Could anyone help?

Question relating to:

Heart Rate monitor example for the Nucleo board and the Bluetooth Low Energy Nucleo board.

2 Answers

9 years ago.

/media/uploads/pyj/nucleo_weather_station_mbed_solution.rar

There is some problem with the sample project. Use this projiect and replace main.cpp.

9 years ago.

Dear users,

please consider that the newest ST library supporting the mbed enabled ST BLE component is the one published here

The supported platforms are listed in the component home page.

The library comes with two updated examples BLE_HeartRate_IDB0XA1|BLE_HeartRate_IDB0XA1 and BLE_BatteryLevel_IDB0XA1.

You are also warmly advised to take care about the Arduino Connector Compatibility Warning in the library home page.

Kind regards