LPCXpresso11U68

Firmware update required

Please make sure you have updated your LPCXpresso to the latest firmware to enable the mbed flash disk interface

Overview

The LPC11U6x are an ARM Cortex-M0+ based, low-cost 32-bit MCU family operating at CPU frequencies of up to 50 MHz. The LPC11U6x support up to 256 kB of flash memory, a 4 kB EEPROM, and 36 kB of SRAM. The ARM Cortex-M0+ is an easy-to-use, energy-efficient core using a two-stage pipeline and fast single-cycle I/O access. The peripheral complement of the LPC11U6x includes a DMA controller, a CRC engine, one full-speed USB device controller with XTAL-less low-speed mode, two I2C-bus interfaces, up to five USARTs, two SSP interfaces, PWM/timer subsystem with six configurable multi-purpose timers, a Real-Time Clock, one 12-bit ADC, temperature sensor, function-configurable I/O ports, and up to 80 general-purpose I/O pins.

LPCXpresso Pinout (Rev.B) LPCXpresso Pinout (Rev.C)

Features

  • NXP LPC11U68 MCU
    • ARM® Cortex™-M0+ Core
    • 50MHz, 36KB RAM, 256KB FLASH
    • USB Device, 2xSPI, 2xI2C , UART, ADC, GPIO
  • Arduino form-factor
    • Leveraging the standard
    • Compatible with a wide range of commercially available shields
    • Built-in USB drag 'n' drop FLASH programmer
  • mbed.org Developer Website
    • Online Compiler
    • High level C/C++ SDK
    • Active devleoper community

Further reading

 Buy Now


Please log in to start a discussion or ask a question.

Discussion topics

TopicRepliesLast post
InterruptIn broken in LPC11U68 target! 1 13 Oct 2017 by Toyomasa Watarai
AnalogIn Extremely Slow 4 05 Jun 2014 by Neil Thiessen
Using UART1 with LPCExpresso11U68 2 29 May 2014 by Jurgis Jurksta

Questions

See more related questions