PixArt Imaging / Pixart_OTS_PMT9123

Library for PMT9123 for Nordic nRF51

You are viewing an older revision! See the latest version

Homepage

Table of Contents

  1. Setup
  2. Hardware:
  3. Connection:
  4. Supplying Power

This section highlights the setup and operating guide to integrating PMT9213with the ST Nucelo DK board. /media/uploads/pixus_mbed/connection2.jpg

Setup

Hardware:

  • 1. PC or Notebook with Windows Operating System /media/uploads/pixus_mbed/connection2.jpg
  • 2. Nucleo Dev Kit Board from ST Micro
  • 3. PMK9123IP-TVIT Aduino Enabled Board
  • 4. USB Cable (one end with Mini-B)

Connection:

Please connect the board as show below.

/media/uploads/pixus_mbed/connection1.jpg

Supplying Power

Connect the one end of the USB to the PC USB and the other to the Nucleo USB Mini-B as shown in the figure below.

/media/uploads/pixus_mbed/connection2.jpg

I am assuming that you already know and are able to download the code at this point. For ST Nucleo Dev Board, no RESET is needed after the code is downloaded. You should observe that the RED LED will change color to GREEN after the code is download successfully.

All wikipages