Nothing Special / mbed-STM32F103C8_org

Modification of Mbed-dev library for LQFP48 package microcontrollers: STM32F103C8 (STM32F103C8T6) and STM32F103CB (STM32F103CBT6) (Bluepill boards, Maple mini etc. )

Fork of mbed-dev by mbed official

Library for STM32F103C8 (Bluepill boards etc.).
Use this instead of mbed library.
This library allows the size of the code in the FLASH up to 128kB. Therefore, code also runs on microcontrollers STM32F103CB (eg. Maple mini).
But in the case of STM32F103C8, check the size of the resulting code would not exceed 64kB.

To compile a program with this library, use NUCLEO-F103RB as the target name. !

Changes:

• Corrected initialization of the HSE clock (mbed bug), allowing the use of on-board xtal (8MHz).⁽¹⁾
• Additionally, it also set USB clock (48Mhz).⁽²⁾
• Definitions of pins and peripherals adjusted to LQFP48 case.
• Board led LED1 is now PC_13 ⁽³⁾
• USER_BUTTON is now PC_14 ⁽⁴⁾
  
  

notes
⁽¹⁾ - In case 8MHz xtal on board, CPU frequency is 72MHz. Without xtal is 64MHz.
⁽²⁾ - Using the USB interface is only possible if STM32 is clocking by on-board 8MHz xtal or external clock signal 8MHz on the OSC_IN pin.
⁽³⁾ - On Bluepill board led operation is reversed, i.e. 0 - led on, 1 - led off.
⁽⁴⁾ - Bluepill board has no real user button

/* mbed Microcontroller Library
 * Copyright (c) 2006-2013 ARM Limited
 *
 * Licensed under the Apache License, Version 2.0 (the "License");
 * you may not use this file except in compliance with the License.
 * You may obtain a copy of the License at
 *
 *     http://www.apache.org/licenses/LICENSE-2.0
 *
 * Unless required by applicable law or agreed to in writing, software
 * distributed under the License is distributed on an "AS IS" BASIS,
 * WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
 * See the License for the specific language governing permissions and
 * limitations under the License.
 */
#ifndef MBED_PORTMAP_H
#define MBED_PORTMAP_H

#include "device.h"

#if DEVICE_PORTIN || DEVICE_PORTOUT

#ifdef __cplusplus
extern "C" {
#endif

typedef struct port_s port_t;

PinName port_pin(PortName port, int pin_n);

void port_init (port_t *obj, PortName port, int mask, PinDirection dir);
void port_mode (port_t *obj, PinMode mode);
void port_dir  (port_t *obj, PinDirection dir);
void port_write(port_t *obj, int value);
int  port_read (port_t *obj);

#ifdef __cplusplus
}
#endif
#endif

#endif