Publishing for Bluetooth Asia 2018 developer session: mesh session. This repo is for GenericOnOff client side firmware.
You are viewing an older revision! See the latest version
Homepage
EULA¶
PLEASE READ EULA.TXT BEFORE START DEVELOPMENT.
Overview¶
This sample demonstrates Bluetooth Mesh functionality on micro:bit. It doesn't need provisioning because all the credential material (DevKey, NetKey, AppKey, Key Index, IVI and Unicast address) is pre-configured. This sample work as a GenericOnOff client:
- Pressing Button A on micro:bit will send GenericOnOffSet access message with on or off state alternatively and specific group address;
- Pressing Button B on micro:bit will switch the group address from 0xC000 to 0xC003 and back to 0xC000 again like round robin;
Requirements¶
micro:bit board
Building and Running¶
0. Download source code, it's zip file, the link is on this page, Download repository
.
1. Following below link to set the development environment up on your Windows computer. http://docs.zephyrproject.org/getting_started/installation_win.html
2. copy zip file into ./zephyr/sample/
in the Zephyr tree.
3. unzip the file by "Extract Here".
3. access into the extracted folder and rename prj_bbc_microbit.txt
to prj_bbc_microbit.conf
4. if adopting Windows Command Prompt, use it to access into the unzip folder and type following commands on the console:
mkdir build & cd build
cmake -GNinja -DBOARD=bbc_microbit ..
ninja
if adopting MSYS2, use it to access into the unzip folder and type following commands on the console:
mkdir build & cd build
cmake -GNinja -DBOARD=bbc_microbit ..
ninja
5. connect micro:bit with your computer by USB cable, the board will be enumerated as a massive storage device;
6. drag the hex file (which is in ./zephyr/sample/[unzip folder]/build/zephyr/zephyr.hex
) into
Microbit massive storage device to flash the firmware;
7. micro:bit is ready to work as a GenericOnOff client.