mbed library sources: Modified to operate FRDM-KL25Z at 48MHz from internal 32kHz oscillator (nothing else changed).

Fork of mbed-src by mbed official

The only file that changed is: mbed-src-FLL48/targets/cmsis/TARGET_Freescale/TARGET_KL25Z/system_MKL25Z4.h

common/board.c

Committer:
icenyne
Date:
2013-10-26
Revision:
30:7ca55132b805
Parent:
9:0ce32e54c9a7

File content as of revision 30:7ca55132b805:

/* mbed Microcontroller Library
 * Copyright (c) 2006-2013 ARM Limited
 *
 * Licensed under the Apache License, Version 2.0 (the "License");
 * you may not use this file except in compliance with the License.
 * You may obtain a copy of the License at
 *
 *     http://www.apache.org/licenses/LICENSE-2.0
 *
 * Unless required by applicable law or agreed to in writing, software
 * distributed under the License is distributed on an "AS IS" BASIS,
 * WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
 * See the License for the specific language governing permissions and
 * limitations under the License.
 */
#include "gpio_api.h"
#include "wait_api.h"
#include "toolchain.h"

WEAK void mbed_die(void);
WEAK void mbed_die(void) {
#if   defined(DEVICE_ERROR_RED)
    gpio_t led_red; gpio_init(&led_red, LED_RED, PIN_OUTPUT);

#elif defined(DEVICE_ERROR_PATTERN)
    gpio_t led_1; gpio_init(&led_1, LED1, PIN_OUTPUT);
    gpio_t led_2; gpio_init(&led_2, LED2, PIN_OUTPUT);
    gpio_t led_3; gpio_init(&led_3, LED3, PIN_OUTPUT);
    gpio_t led_4; gpio_init(&led_4, LED4, PIN_OUTPUT);
#endif
    
    while (1) {
#if defined(DEVICE_ERROR_RED)
        gpio_write(&led_red, 1);

#elif  defined(DEVICE_ERROR_PATTERN)
        gpio_write(&led_1, 1);
        gpio_write(&led_2, 0);
        gpio_write(&led_3, 0);
        gpio_write(&led_4, 1);
#endif
        wait_ms(150);

#if   defined(DEVICE_ERROR_RED)
        gpio_write(&led_red, 0);

#elif defined(DEVICE_ERROR_PATTERN)
        gpio_write(&led_1, 0);
        gpio_write(&led_2, 1);
        gpio_write(&led_3, 1);
        gpio_write(&led_4, 0);
#endif
        wait_ms(150);
    }
}