Data acquisition and device control with Scilab.

Dependencies:   Servo MPU6050

Desciription

Scilab is a freeware alternative to MATLAB. For low-cost data acquisition and device control a nice Arduino toolbox is available.

https://os.mbed.com/media/uploads/hudakz/scilab.png

This site presents a Mbed port which allows to use Mbed boards (equipped with Arduino header) rather than Arduino to import real time data into Scilab and to control real equipment witch Scilab.

https://os.mbed.com/media/uploads/hudakz/arduino-temp-read_imagelarge_1.jpeg

Installation
  • Install Scilab to your PC, if not done yet.
  • Launch Scilab and install the Arduino toolbox by executing the following command from the Scilab console:

--> atomsInstall("arduino")
Controlling Mbed's digital output from Scilab
  • In Xcos open examples/Arduino1.zcos

/media/uploads/hudakz/scilab_arduino1.png

  • Double click on the Board setup block and replace the serial port number with mbed's actual virtual serial port number.
  • Double click on the Digital WRITE block and set Digital Pin to 13 (D13 is connected to LED1).
  • Start simulation and LED1 on the Mbed board should start blinking.
Reading and displaying Mbed's analog input
  • In Xcos open examples/Arduino2.zcos

/media/uploads/hudakz/scilab_arduino2.png

  • Double click on the Board setup block and replace the serial port number with mbed's actual virtual serial port number.
  • Double click on the Analog READ block and set Analog Pin to 2.
  • Start simulation and a graph should appear showing the analog signal measured on Mbed's pin A2.

NOTE: Currently, there is bug in the toolbox ARDUINO_ANALOG_READ_sim function (I have reported to Scilab) so the analog readings are not correct.

/media/uploads/hudakz/scilab_graph.png

PID controller
  • In Xcos open examples/Arduino9.zcos

/media/uploads/hudakz/scilab_arduino9.png

History

Data acquisition and device control with Scilab. default tip

2021-01-18, by hudakz [Mon, 18 Jan 2021 19:51:22 +0000] rev 0

Data acquisition and device control with Scilab.