After being frustrated by the SPI system's performance, I ended up using an approach inspired by Paul Stoffregen's OctoWS2811. This uses 3 of the 4 DMA channels triggered by the TPM0 timer PWM and overflow events.

This design will allow for up to 16 strings of up to 60 (limited by RAM space) WS2811/WS2812 LEDs to be driven on a single port.

Note though that the 3.3V output from the FRDM-KL25Z's GPIO pins is OUT OF SPEC for driving the 5V WS2812 inputs, which require 3.5V for a logic HIGH signal. It only works on my board if I don't connect my scope or logic analyzer to the output pin. I recommend that you add a 5V buffer to the outputs to properly drive the LED strings. You could use something like a CD74HCT244 to do this.

Adding more strings takes the same time to DMA, because the bits are output in parallel.

The way I have my code set up, I can use up to 8 pins on PORTD. However, changing the defines at the top of WS2811.cpp will change the selected port.

Alternatively, you could use another port to get more strings. Watch out for pin mux conflicts, though.

Here are your choices:

• PORTE: 15 total: PTE0-PTE5, PTE20-PTE25, PTE29-PTE31
• PORTD: 8 total: PTD0-PTD7
• PORTC: 16 total: PTC0-PTC13, PTC16-17
• PORTB: 16 total: PTB0-PTB11, PTB16-19
• PORTA: 15 total: PTA0-PTA5, PTA12-PTA20

Here is how the DMA channels are interleaved: