File content as of revision 0:c674504a6536:

// control pins for I/O

DigitalOut CS(p23);     /* chip select the SSD1963 active LOW */
DigitalOut RS(p22);     /* reset  to SSD1963  - not used in this implementation*/
DigitalOut nWR(p25);    /* write out to SSD1963 active LOW */
DigitalOut nRD(p24);    /* read data from SSD1963 active LOW - but not used */
DigitalOut DC(p26);     /* Data/Command Select: 0=Command,  1=Data); */
DigitalOut myled(LED1); /* for test purposes only - on the mbed module */
DigitalOut led(p18); 
DigitalOut WEAK(p30); 
DigitalOut SDN(p19); 

/**************************** data bus I/O pins *********************************/
BusOut DB(p10,p11,p12,p13,p14,p15,p16,p17);  
/******************************************************************************/
int touch_x, touch_y;
int back_color;
char is_touch = 0;
char buffer[100];
char button_poss = 0;
/* System Definitions */
/* the  following are the pin assignments on the mbed controller */
//DigitalOut pga2320(p30);/* normally LOW; take HIGH  to select PGA2320 */
//DigitalOut phono(p29);
//DigitalIn IRx(p27);     /* p28 is the Tx outputand is not used */
//DigitalIn IPSELPB(p26);
//DigitalIn IPSELB(p25);
//DigitalIn IPSELA(p24);
//DigitalIn VOLPB(p23);
//DigitalIn VOLB(p22);
//DigitalIn VOLA(p21);
//AnalogIn ALS(p20);
//DigitalOut SBUSON(p19);
//DigitalOut NAOE(p18);       /* A6821 output enable.  Active LOW */
//DigitalOut DC(p17);
//DigitalOut RD(p16);         /* also ASTROBE */
//DigitalOut WR(p15);         /* MDATA */
//DigitalOut RS(p14);         /* ACLK */
//DigitalOut CS(p13);
//DigitalOut myled(LED1);
//BusInOut DB(p12, p11, p10, p9, p8, p7, p6, p5); /* for the LCD display */

//Serial pc(USBTX, USBRX);    /* for debugging and in final version for test mode */
//Serial remote(NC, p27);     /* remote control serial input; 1200bd 8 data, 1 stop and no parity */
//AnalogIn light(p20);        /* for auto display brightness */