Just Kramer

Activity

Reply to Documentation bug: digital I/O current - Rene Greiner wrote: Of course, as Ohm's law says U=I*R. No R means no U …
Just Kramer - 21 Mar 2012
Reply to Need logic input pin electrical specs - Good analysis of the logic specs, appreciate the help. If you don't mind, I would …
Just Kramer - 21 Mar 2012
New topic Documentation bug: digital I/O current - I believe the specification for digital output current shown on this page is not exactly …
Just Kramer - 21 Mar 2012
New topic Website problem - I found that the LPC1768 specification on the website gives a faulty PDF - most …
Just Kramer - 20 Mar 2012
Reply to Compile Only - Yes, a Code Check button.
Just Kramer - 20 Mar 2012
Reply to Need logic input pin electrical specs - I think I have an answer but I STILL would like someone to do a …
Just Kramer - 20 Mar 2012
New topic Need logic input pin electrical specs - Are the logic inputs TTL or CMOS? Could not find on this page: http://mbed.org/handbook/mbed-NXP-LPC1768 It …
Just Kramer - 19 Mar 2012
Reply to PWM program - Muhammad A Khalid wrote: i am also trying to generate pwm of varying frequency i.e. …
Just Kramer - 19 Mar 2012
Reply to PWM program - Wim Huiskamp wrote: Out.period() starts the pulsestream but default pulsewidth is 0. So as soon …
Just Kramer - 10 Mar 2012
Reply to PWM program - Fred, thank you for the suggestions. I can't really understand from the handbook what the …
Just Kramer - 10 Mar 2012
New topic PWM program - Hello, what I am trying to do is to send 10000 pulses out, increase the …
Just Kramer - 09 Mar 2012
New topic Trying to save my source to a text file - But 1) there is no "Save as..." 2) the buttons are grayed out. Help?
Just Kramer - 09 Mar 2012
Reply to Embedding the MBED - hardware interface - Exactly what I needed. Apologies for not scrolling down far enough, and thanks for the …
Just Kramer - 09 Mar 2012
New topic Improvement to handbook - embedding the board - Deleted by OP - the information was on the page and I did not see …
Just Kramer - 09 Mar 2012
Reply to Embedding the MBED - hardware interface - Thank you. The only specs I can find for power input are on the pinout …
Just Kramer - 09 Mar 2012
New topic Embedding the MBED - hardware interface - Beginner here. Have looked over the handbook and cannot find the interface specification, including providing …
Just Kramer - 09 Mar 2012
Reply to Print function? - I'll try printf over USB, thanks.
Just Kramer - 05 Mar 2012
New topic Copy and paste on a Mac - I see there has been discussion about copying text from the source code window onto …
Just Kramer - 05 Mar 2012
New topic Print function? - hello, newcomer here. Was wondering if there is a way to print information either while …
Just Kramer - 05 Mar 2012
Reply to Are these classes? - Simon, good explanation. Just trying to get the terminology right - thanks.
Just Kramer - 04 Mar 2012